Troubleshooting—Continued
DS-A1XP RI Dock for iPod
There’s no sound
•Make sure your iPod is actually playing.
•Make sure your iPod is inserted properly in the RI Dock.
•Make sure the RI Dock is connected to the correct input jacks on the AV receiver. Do not connect it to any output jacks.
•Make sure the AV receiver is turned on, the correct input source is selected, and the volume is turned up.
•Make sure the plugs are pushed in all the way.
•Make sure the AC adapter is connected to a suitable wall outlet and connected to the RI Dock.
•Try resetting your iPod.
The AV receiver’s remote controller doesn’t control your iPod
•3rd generation iPods are not supported.
•Make sure your iPod is properly inserted in the RI Dock. If your iPod is in a case, it may not connect properly to the RI Dock. Always remove your iPod from the case before inserting it into the RI Dock.
•The iPod cannot be operated while it’s displaying the Apple logo.
•Make sure you’ve selected the right remote mode.
•Check the RI Dock’s RI MODE switch setting.
•When you use the AV receiver’s remote controller, point it toward your AV receiver.
•The RI Dock must be connected to the AV receiver
with both an 
cable and an audio cable.
•If you still can’t control your iPod, start playback by pressing your iPod’s Play button. Remote operation should then be possible.
The AV receiver unexpectedly selects your iPod as the input source
•Always pause iPod playback before selecting a differ- ent input source. If playback is not paused, the Direct Change function may select your iPod as the input source by mistake during the transition between tracks.
Recording
Can’t record?
•On your recorder, make sure the correct input is selected.
•To prevent signal loops and damage to the AV receiver, input signals are not fed through to outputs with the same name (e.g., TAPE IN to TAPE OUT, or VIDEO 1 IN to VIDEO 1 OUT).
Others
The sound changes when I connect my head- phones?
•When a pair of headphones is connected, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono, Direct.
How do I change the language of a multiplex source?
•Use the “Multiplex” setting on the “4. Audio Adjust” menu to select Main or Sub (page 52).
The 
functions don’t work?
•To use 
, you must make an 
connection and an analog audio connection (RCA) between the compo- nent and AV receiver, even if they are connected digi- tally (page 35).
The AV receiver contains a microcomputer for signal pro- cessing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.
Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit’s malfunction. Before you record important data, make sure that the material will be recorded cor- rectly.
Before disconnecting the power cord from the wall out- let, set the AV receiver to Standby.
61
