Onkyo HTP-L50 Feature, Control positions and names, ■Subwoofer SL-105, from these terminals, Green: Unit is in operation, Red: Unit is in standby mode, Notes:, Rear panel

Feature

The HTP-L50 is a 5.1-channel speaker package that consists of five satellite speakers and one subwoofer with an internal amplifier.

The HTP-L50 features the SL-105 subwoofer with L/R mixing circuits and a built-in cut-off filter as the subwoofer and the D-L1 speakers with MDF (Medium Density

Fiberboard) cabinet and OMF-cone as the five satellite speakers. Simply connect the speakers to your AV amplifier or receiver for superb surround audio playback.

The speaker cables and satellite speaker terminals are color- coded to facilitate connection. Connect each cable to the matching-colored terminal.

Control positions and names

■Subwoofer SL-105

Front panel	2			3
SL-105
		POWERED SUBWOOFER
	FREQUENCY		OUTPUT LEVEL
	50Hz	200Hz	MIN	MAX
				POWER

1

1POWER switch and indicator

Pressing this button turns the power on (the indicator lights). Pressing the button again turns the power off (the indicator goes out).

Red: Unit is in standby modeGreen: Unit is in operation

2FREQUENCY knob

Use this knob to select the high-frequency range at which you wish to cut off the signal to the subwoofer. You can select any frequency between 50 Hz and 200 Hz depending on the characteristics of the speaker system being used with the SL-105.

3OUTPUT LEVEL knob

Use this knob to adjust the output level of the subwoofer.

Rear panel

SL-105					C
	SPEAKER LEVEL				LINE	AUTO STANDBY
	+	R _	_		INPUT
				L	+
	INPUT
	FROM
	AMP/RECEIVER				L
					(MONO)
						OFF ON
	OUTPUT				R
	TO SPEAKERS	R _	_
	+			L	+

D A B

To AC outlet

ALINE INPUT jacks

Connect these jacks to the LINE OUT jacks of the amplifier etc.

BAUTO STANDBY switch

This switch is used to turn on and off the auto standby function.ON: This activates the auto standby function.

If a constant level signal is not received from the amplifier (or receiver) over a period of a few minutes, the SL-105 automatically enters the standby state. If a constant level signal is later received from the amplifier (or receiver), the power is automatically turned back on.

OFF: Deactivates the auto standby function.

Notes:

•The auto standby function operates on the existence or absence of a constant level input signal. If the auto standby function does not operate properly, try slightly increasing (or decreasing) the output level of the amplifier or receiver.

(Note that output levels of some amplifiers and receivers cannot be adjusted. For more details regarding your components, refer to the instruction manual supplied with them.)

•If noise from peripheral components causes the incorrect operation of the auto standby function, or if outputting low volumes (i.e., during the nighttime) causes the auto standby function to activate, turn off the auto standby function.

•The auto standby function only operates while the power switch for the SL-105 is turned on.

CSPEAKER LEVEL INPUT terminals

Connect these input terminals to the speaker output terminals of your amplifier or receiver.

DSPEAKER LEVEL OUTPUT terminals

4	The speaker-level signal to the front speakers is output
	from these terminals.