Preparations
Preparing the remote controller
Installing the remote controller batteries
1 Remove the battery compartment cover by pressing the tab and lifting up the cover.
Using the remote controller
Point the remote controller toward the remote control sensor.
The STANDBY indicator lights up when the unit receives a signal from the remote controller.
Before
2 Insert two AA (R6 or
Carefully follow the polarity diagram (posi- tive + and negative - symbols) inside the
Remote control sensor
30°
30°
Control range
| m |
| 5 |
About | |
(16 | feet) |
| |
Connections using
battery compartment.
3 Replace the compartment cover.
Notes
•Do not mix new batteries with old batteries or dif- ferent kinds of batteries.
•To avoid corrosion, remove the batteries if the re- mote controller is not to be used for a long time.
•Remove dead batteries immediately to avoid dam- age from corrosion. If the remote controller doesn’t operate smoothly, replace both the batteries at the same time.
•The life of the batteries supplied is about six months but this will vary depending on usage.
Notes
•Place the unit away from strong light such as di- rect sunlight or inverted fluorescent light which can prevent proper operation of the remote controller.
•Using another remote controller of the same type in the same room or using the unit near equip- ment which uses infrared rays may cause opera- tional interference.
•Do not put any object such as a book on the re- mote controller. The buttons of the remote con- troller may be pressed by mistake and drain the batteries.
•Make sure the audio rack doors do not have col- ored glass. Placing the unit behind such doors may prevent proper remote controller operation.
•If there is any obstacle between the remote con- troller and the remote control sensor, the remote controller will not operate.
Information Other Operation Preparations
17