Onkyo SKW-204 Controls, Front View, Rear Panel, North American Model, Other Models

SKW204_En Page 5 Monday, March 20, 2006 9:22 AM

Controls

FRONT VIEW

AStandby/On indicator (STANDBY/ON)

This indicator lights up when the power switch is set to the ON position.

Red: The unit is in Standby mode

Green: The unit is in Operational mode

If the power is turned on, the SKW-204 automatically enters Operational mode when a signal is input.

The SKW-204 automatically returns to Standby mode when no signal has been input for a while.

1

REAR PANEL

North American Model

2 3 4

5 6

To AC outlet

BPOWER switch

Press this switch to the ON position to turn on the power. Press it to the OFF position to turn off the power.

CFREQUENCY knob

Use this knob to select the high-frequency range at which to cut off the signal to the subwoofer.

You can select any frequency between 50 Hz and

200Hz, depending on the characteristics of the speaker system.

DPHASE switch

Use this switch to reverse the phase of the SKW-

204.Normally, set the switch to the “NOR” posi- tion. Depending on the connected speakers or the installation environment of the SKW-204 however, the “REV” position may result in better sound. Select the switch position that produces a louder bass sound.

Other Models

7(Only some models)

To AC outlet

EOUTPUT LEVEL knob

Use this knob to adjust the volume of the sub- woofer.

FLINE INPUT jack

Connect this jack to the SUBWOOFER PREOUT jacks on the amplifier etc.

GVOLTAGE SELECTOR (Only some models)

This voltage selector provides compatibility with power systems around the world.

Note:

The auto standby function engages if the input signal level is constant. If the auto standby function does not operate properly, try slightly increasing (or decreasing) the subwoofer output level of the receiver.

5