SKW204_En Page 7 Monday, March 20, 2006 9:22 AM
Adjustments
Crossover frequency and output level
•Adjust the
•Be aware that you might set the subwoofer to a high output level because
Note:
Be careful not to allow the input of excessive power. Input levels that greatly exceed normal situations can damage the
Placement
The placement of the
Corner
1/3 room
length
Troubleshooting
The unit does not turn on
•The power plug is not fully inserted.
➞ Insert the power plug fully into the power outlet.
No sound is output
•The OUTPUT LEVEL knob is set to the MIN level.
➞Set the OUTPUT LEVEL knob properly.
•Pin connector cable is not properly connected to the LINE INPUT jack.
•The speaker setting at the amplifier (or receiver) is incorrect.
➞Check the settings at the amplifier (or receiver).
•The input signal is so small that the unit entered Standby mode.
➞Slightly increase the output level at the amplifier (or receiver).
Low sound output
•The sound source might not include a superbass range.
➞Play a sound source that includes a superbass range.
Hum noise
•Pin connector plug is not inserted completely.
➞Fully insert the pin connector plug.
•External leakage flux (induction noise by TV, etc.) occurs.
➞Relocate the
7