Onkyo SL-107 instruction manual Connections, Connecting to an amplifier’s Subwoofer Preout jack

SL-107_Chi.book Page 5 Tuesday, September 30, 2003 2:43 PM

Connections

For safety considerations, turn off the power to this unit and all other system components before you connect or disconnect any component.

Using the SL-107 with an AV amplifier

When using the SL-107 in conjunction with an AV amplifier or receiver that features surround capability, connect the SL-107 to SUBWOOFER PREOUT jack using the supplied pin connector cable. If you use speaker cable to make the connection, depending on the amplifier or receiver settings, the bass signals may cut out, resulting in decreased fidelity in the low bass range. For more information on proper connection procedures, refer to the instruction manual supplied with your ampli- fier or receiver.

Connecting to an amplifier’s SUBWOOFER PREOUT jack

If your amplifier (or receiver) is equipped with SUB- WOOFER PREOUT jack, connect it to the SL-107’s left LINE INPUT jack.

Amplifier with SUBWOOFER PREOUT jack

(Supplied)

		PHASE
		NOR
		REV
OUTPUT LEVEL	FREQUENCY
	L	R
LINE	(MONO)
INPUT
	SPEAKER LEVEL
INPUT		OUTPUT
FROM		TO SPEAKERS
AMP/RECEIVER

Connecting two channel outputs (when your ampli- fier does not have SUBWOOFER PREOUT jack):

If your preamplifier is equipped with two channel out- puts, connect them to the right and left LINE INPUT jacks on the SL-107.

Preamplifier / Pre-main amplifier

PREOUT

L

To power amplifier

R

PHASE

NOR

REV

OUTPUT LEVEL FREQUENCY

(Not supplied)	L	R
	(MONO)
	LINE
	INPUT
	SPEAKER LEVEL
	INPUT	OUTPUT
	FROM	TO SPEAKERS
	AMP/RECEIVER
	L	L
	R	R
	POWER
OFF	ON

SL-107

L

L

R

R

POWER

OFF ON

SL-107

En-5