Onkyo SL-107 instruction manual Connections-Continued, En-6, Connecting the speaker cables

SL-107_Chi.book Page 6 Tuesday, September 30, 2003 2:43 PM

Connections—Continued

Connecting to speaker terminals on an amplifier (or receiver)

1.Using the speaker cables, connect the SL-107 SPEAKER LEVEL INPUT terminals to the ampli- fier’s speaker terminals.

2.Using the speaker cables, connect the right and left speakers to the SL-107 SPEAKER LEVEL OUT- PUT terminals.

Amplifier		Speaker	Speaker
(or Receiver)		(L ch)	(R ch)
Speaker terminals
+ R	L +
		PHASE
		NOR
		REV
	OUTPUT LEVEL	FREQUENCY

Notes:

•When connecting speaker cables, do not mistake the

(+) and (–) or the L (left) and R (right) terminals. If you connect the speaker cables incorrectly, there will be a loss of fidelity in the bass range.

•The speakers connected to the SL-107 SPEAKER LEVEL OUTPUT terminals must have an impedance equal to or greater than the rating indicated on the amplifier connected to the SPEAKER LEVEL INPUT terminals. Otherwise, the amplifier may be damaged.

•When you connect the speaker

cables, make sure the core wires

do not make contact with other terminals or metallic parts of the unit.

• Do not use BTL (Balanced Trans- former-Less) type amplifiers.

Using a BTL amplifier may damage both the amplifier and the subwoofer. Ordinary amplifiers are not BTL amplifiers. For more information, see the amplifier’s instruction manual.

LINE

L R

(MONO)

INPUT

SPEAKER LEVEL

INPUTOUTPUT

FROM	TO SPEAKERS
AMP/RECEIVER
L	L
R	R

POWER

OFF ON

SL-107

• Connecting the speaker cables

1.Twist the core wires at the stripped end of the cable.

2.Press the lever of the SPEAKER LEVEL terminal, fully insert the twisted core wires into the terminal hole, and then release the lever.

1.

2.

3. Pull the speaker cable gently to 3.

ensure that it is connected firmly.

En-6