Onkyo TX-SR674 First Time Setup, Connect the setup microphone to the Setup MIC jack, Press Enter

First Time Setup—Continued

2

Put the speaker setup micro-		4	The speaker detect results
phone at measurement point 1.			appear.
				Auto Speaker Setup
	Auto Speaker Setup
	========================			========================
	Please place microphone			----SP Detect Result----
	at center of listening			FL:Yes	FR:Yes
	area at ear height.			SL:Yes	SR:Yes
				SBL:Yes	SBR:Yes
	Push Enter:Next			C:No	SW:Yes
				------------------------
				Next
				Retry
				Cancel

Notes:

•Make sure the microphone is hori- zontal.

•If there’s an obstacle between the microphone and any speaker, the automatic setup will not work cor- rectly. Set up the room as you would when enjoying a DVD.

•Positioning the microphone close to where your ears would normally be will provide better results. You can adjust the height of the microphone by using a tripod or level table.

•It takes about 10 minutes to complete the automatic speaker setup.

Connect the setup microphone to the SETUP MIC jack.

Notes:

“Yes” means that the speaker was detected. “No” means that no speaker was detected.

If you agree with the results, use the Up and Down []/[ ] but- tons to select Next, and then press [ENTER].

The options are:

Next:

Proceed to the next step.

Retry:

Return to step 2 and try again.

Cancel:

Cancel the automatic speaker setup.

3

•If the AV receiver was previously muted, it will be unmuted.

•Automatic speaker setup cannot be performed while a pair of head- phones is connected.

Press [ENTER].

The automatic speaker setup starts.

Auto Speaker Setup

========================

Do not unplug Setup Mic.

Please, keep quiet.

Now measuring...

A test tone is output by each speaker in turn, as the Audyssey2EQ function determines which speakers are con- nected. This takes a few minutes.

Note:

If any extraneous noise is picked up by the microphone, the automatic setup may not work correctly, so don’t make any noise.

39