10
The 5-band frequency equalizer controls
these frequencies:
100 Hz — low-bass range (bass
drums); reduces rumble or other
low-frequency noise
300 Hz — low frequencies (organ
notes)
1 KHz — here is where the ear is
most sensitive (lo w vocals)
3.3 KHz — mid-range high frequen-
cies (high vocals)
10 KHz — high-frequency sounds
(cymbals, flutes, and violins)
LOADING A CASSETTE TAPE
The system has two cassette decks —
TAPE 1 and TAPE 2. Use both decks for
normal playback or consecutive play.
Additionally, TAPE 1 can record cas-
sette tapes.
Note: Before playing or recording any
cassette tape, take up any slack in the
tape by turning one of the cassette’s
hubs with a pencil. If you do not remove
excess slack, the tape could become
tangled in the record/playback mecha-
nism.
Follow these steps to load a cassette
tape into either deck.
1. Press STOP/EJECT to open the cas-
sette compartment door.
2. Put the cassette tape inside the
door with its open edge down, the
desired side facing out, and the full
reel on the left.
3. Press in the cassette compartment
door to close it.
PLAYING A CASSETTE TAPE
Warnin
g
: To prot ect your hearing, set
VOLUME to its lowest setting before you
begin playing a cassette tape.
You can play a cassette tape in either
TAPE 1 or TAPE 2, or you can load
tapes in both decks and play them con-
secutively.
32-1162.fm Page 10 Monday, Augus t 9, 19 99 3:0 1 PM