Optimus PRO SW-200P manual Connecting To Power, Adjusting The Volume

40-4081.fm Page 5 Wednesday, August 11, 1999 11:02 AM

If you use MEGACABLEâ or any other high quality, low gauge speaker wire, the terminals will be too small to ac- commodate the wires from both the left (or right) speaker and the PRO SW-200P. You need two pairs of Speaker Pins (RadioShack Unlimited No. 10458503) to make the connec- tion. Follow these steps to connect the wires to each terminal using Speaker Pins.

1.Twist together the ends of the wires from the left speaker’s posi- tive terminal and the amplifier/ receiver’s left positive speaker ter- minal.

To PRO SW-10P

From

Amplifier/

Receiver

From left or right speaker (be sure to match polarity)

2.Position the twisted wire ends between the open barrel ends of the Speaker Pin.

3.Using a pair of pliers, crimp down the open barrel ends of the Speaker Pin to hold the wire ends in place.

4.Plug the Speaker Pin into the proper terminal on the PRO SW- 200P.

CONNECTING TO

POWER

Plug the PRO SW-100P’s AC power cord into an AC outlet.

ADJUSTING THE

VOLUME

Once you have made all connections, follow these steps to adjust the volume control.

1.Rotate VOLUME CONTROL on the front of the subwoofer to MIN.

2.Turn on your amplifier/receiver and another component (such as a radio, cassette player, CD player, or turntable).

3.Begin play of an audio source (such as a CD) and adjust the amplifier/speaker’s overall volume to a comfortable level. Rotate VOL- UME CONTROL clockwise, a little at a time, until you achieve a pleasing balance of bass between the PRO SW-200P and the main speakers (and satellite speakers, if used). Bass output should not overpower the main speakers, but should blend across the entire musical range.

Once you have adjusted VOLUME CONTROL, use the amplifier/ receiver’s volume control to con- trol the speakers’ volume.

5