E N G L I S H
Troubleshooting
Service problems that appear to be major can often be solved easily. You can be your own troubleshooter
by reviewing this guide. All other servicing should be done by an Oreck authorized service center.
Problem | Check | What to do | |
|
|
| |
Unit does not turn on. | • Power Cord | • Plug in the power cord. | |
| • Power Button | • Set power button for desired blower speed. | |
| • Front Grill | • | Reinsert front grill, sliding right until it locks |
|
|
| into place. |
| • Top Cover | • Top cover should be replaced and slid back to lock. | |
|
|
| |
“Check Collector Cell” | • Truman Cell™ | • Wash Truman Cell™. Make sure it is | |
has turned red. |
|
| thoroughly clean and dry before reinstalling. |
|
| • Hold down theAir Revitalizer button until the light | |
|
|
| blinks three times to reset the timer after cleaning. |
|
|
| |
“Check Collector Cell” | • Truman Cell™ | • Truman Cell™ may need cleaning. | |
light is flashing red. |
|
| Clean Truman Cell™. |
|
| • Truman Cell™ may not be completely dry. | |
|
|
| Allow it to air dry longer. |
|
| • Truman Cell™ may be damaged. | |
|
|
| Contact Oreck for service. |
Unit does not | • Truman Cell™ | • Wash Truman Cell™. Make sure it is | |
remove pollutants. |
|
| thoroughly clean and dry before reinstalling. |
|
|
| |
Unit sparks, crackles | • Truman Cell™ | • Sparking or popping noise (arcing) can occur | |
and pops. |
|
| when dust particles build up in the Truman |
|
|
| Cell™. Gently wipe the cell wires with a dry |
|
|
| cotton swab, or clean the entire cell with |
|
|
| |
|
| • | If excessive arcing continues after proper |
|
|
| cleaning, the cell may be damaged or wet. |
|
|
| If damaged contact Oreck for service. |
|
|
| |
“Check Odor Absorber” | • Odor Absorber | • Hold down the Night Light button until the | |
light has turned red. |
|
| light blinks three times to reset the Check |
|
|
| Odor Absorber timer after replacing. |
|
| • | Replace odor absorber if desired. |
|
| • | If the odor absorber is not replaced, remove |
|
|
| old odor absorber to turn off “Check Odor |
|
|
| Absorber” light. |
Does not remove odor. | • Odor Absorber | • Vacuum odor absorber with a soft brush | |
|
|
| attachment if dirty. Do not use any liquids to |
|
|
| clean the odor absorber. |
|
| • | Replace odor absorber if desired. |
|
|
| |
Unit still does not | • Check all the | • Contact Oreck for service. | |
operate properly. | above points. |
|
|
|
|
|
|
11