E N G L I S H
SPECIALNORMAL
20 | 21 | 22 | 23 | 24 | 25 |
Replacing Edge Brush
WARNING: Unplug cord from electrical outlet before servicing.
26Turn the power head over. With baseplate facing up, remove the screw located in the center of each edge brush.
Remove both edge brushes and replace with new ones. Replace both screws and tighten.
Replacing the LED Light
The light assembly should be replaced by an Oreck authorized service center whenever it fails to light during operation.
Stuffing or Blockage | 26 |
IMPORTANT: On plush and new carpets, stuffing may occur inside the intake tube and the lower tube assembly. This is due to excessive fuzz and loose cuttings in the carpet. Stuffing could occur for the first few cleanings until all the loose material is removed. Due to the high efficiency of the cleaner, many older carpets will cause stuffing when the cleaner is first used on them. If your vacuum cleaner does not pick up properly, or makes unusual noise and the outer bag does not fluff up or balloon open, follow these steps:
WARNING: Unplug cord from electrical outlet before servicing.
27Check for blockage at the mouth of the intake opening. If there is blockage, remove it with
a screwdriver or coat hanger. If you can not reach the blockage, remove baseplate. Remove the base plate by removing 5 screws (see “Adjusting or Replacing Brushroll”).
28If the blockage is not at the base, remove lower tube. Unhook bag spring, releasing bottom of bag. Open elcroed Outer bag lower cover to gain access to Collars and Lower Tube.
29Twist lower collar counterclockwise to slide up. Pull tube out of base. Check for blockage. If blockage is in the tube, remove with a coat hanger.
30If tube is not blocked, look into fan housing. Remove debris with
31To reassemble, check
32Insert tube and push down until the tube is seated. Make sure
33Many times blockage occurs due to a full dust bag causing dirt to back down the air flow system. When that
happens, the blockage will be at the top of the system, starting in the area where the dust bag connects to the connector assembly. Note: If the above actions do not correct the problem, contact an Oreck authorized service center or call the
customer service center. US:
27 | 28 | 29 | 30 | 31 | 32 | 33 |
Velcro® is a registered trademark owned by Velcro Industries B.V. Limited Liability Company Netherlands.