E N G L I S H
Operating Instructions
The standard nozzle is adjustable for use on
CARPET carpets (without brush) or hard floors (with brush).
BARE FLOOR
Replacing Filter Bag
Check bag frequently or when bag full indicator has been activated.
Note: If picking up fine debris, change bag more frequently.
BAG FULL
INDICATOR
INDICATOR
LIGHTS
RESET BUTTON
To adjust suction, use the suction control on the handle.
Upholstery tool, crevice tool and dusting brush can be found in storage compartment.
Small accessories can be used with friction wand or handle alone.
Note: Under proper operating conditions a green indicator light on the power nozzle will illuminate. If roller brush becomes stalled, a red indicator light will illuminate. Remove clog or source of stall, and press the red reset button on the back of the power nozzle to continue use.
Switch the unit off. Unplug unit from wall outlet. Open the cover by lifting the latch in front of the intake.
Remove dust bag by raising handle on bag carrier and lifting carrier out.
Remove the bag from carrier by pulling the cardboard tag. The Saniseal® dust seal will close automatically.
Insert a new bag into carrier by sliding cardboard into slots on carrier until bag is fully inserted. Bend rear part of dustbag downwards.
Replace the carrier into the unit.
Close the cover by pressing it down until it latches. The cover cannot be closed if a bag is not present or inserted properly.
7
