Assembly
To Replace Paper
Filter Dust Bag
To assist you in identifying components of your vacuum, the parts have been numbered as follows:
1 Handle tube, upper
2 Tube, lower
3Power head
4Outer bag
5 Paper filter dust bag | 5 |
6Power cord
7Retaining spring
8Bag tension bar
9Zip fastener
10 On/off switch
11Cord hook
12Plastic loop/cable clamp
13Connector assembly
14Fan housing
15Cord assembly
16Cord Strain Relief Assembly
10 
9 | 11 | |
1 | ||
12 | ||
| ||
| 16 | |
13 |
| |
4 |
|
2
6
8 | 7 | 14 | 15 |
|
| ||
| 3 |
|
|
WARNING: Unplug cord from electrical outlet before servicing.
BAG REMOVAL:
1.Unsnap bag door from base.
2.Gently pull bag from
cardboard collar upwards.
1 | 2 |
| TAB |
3 | Before assembling appliance, |
| remove two screws from |
| connector assembly. Remove |
| cardboard insert by pulling |
| upward (fig 1). |
| With ON/OFF switch facing the |
| front of the unit, slide upper |
| handle tube over matching |
| section of the connector |
| assembly. Hold tab of cord |
strain relief flush with TOP hole in connector assembly. Insert screw through hole in tab of cord strain relief and firmly tighten to connector assembly. Insert remaining screw in bottom hole of connector assembly and tighten firmly (fig 2).
NOTE: The power cord comes installed in the cord strain relief. Should the power cord come loose, simply pinch the power cord together and slide approximately 1 - 2 inches through hole in cord strain relief. Carefully slide power cord over clamp on the cord strain relief and pull excess until the power cord is tightly rested under clamp.
Attach cord to cord clip by pressing cord above and below clip ensuring the cord is fully rested in clip (fig 3).
3.XL2605HH: Dust seal will close automatically
BAG INSTALLATION:
1.Slide the cardboard collar completely onto bag dock
door.
ENFONCEZ JUSQU’À
ENTENDRE UN BRUIT
PRESIONE HASTA
ESCUCHAR UN
CHASQUIDO DE SUJECIÓN
2.Firmly push bag dock door with both thumbs on indication point until
it snaps.
4
