Oreck U4300 manual Operation, Assembling the Handle Tube, Operating the Vacuum, E N G L I S H

E N G L I S H

Operation

Assembling the Handle Tube

1Before assembling appliance, remove two screws from the connector assembly. Remove insert by pulling upward.

2Slide upper handle section over the matching section of the connector assembly. Insert short screw into top hole and long screw into the bottom hole then tighten firmly until handle is no longer loose.

3Snap cord assembly into the cord clip located on the left side of the collar. Leave excess cord at the power head to allow movement.

		Upper
		Handle
	Connector		3
1	Assembly	2

Operating the Vacuum

Make sure the HEPA Filtration Odor Fighting Bag is in place. DO NOT operate the cleaner without a dust bag. Plug the power cord into an electrical outlet and press the On ( l ) - OFF ( O ) switch on handle assembly when ready to operate.

4Up-Position Lock - Place foot on power head and lean handle back gently to release lock for vacuum use. Return handle to the full upright position to engage lock. Note: Do not operate the unit while in the upright and locked position. Do not let the unit run while in any one stationary position for any period of time.

Keep the unit moving while in operation.

5Easy Power Cord Storage - Wrap power cord around cord hook on handle and cord hook on connector. Secure to “U” shaped part on plug.

45

Replacing the HEPA Filtration Odor Fighting Bag

WARNING: Unplug cord from electrical outlet before servicing.

BAG REMOVAL:

6Unzip outer bag completely.

7Pull bag cardboard collar to release bag dock door from connector. Bag dock door will hinge downward.

8Gently pull bag cardboard collar upward out of the bag dock. Saniseal® dust seal will close automatically.

BAG INSTALLATION:

9Slide the cardboard collar completely onto bag dock door.

10Firmly push bag dock door with both thumbs on indication point until it snaps.

6 7 8 9 10

4