Oreck USER'S GUIDE warranty Filling Your Canister Vapor Cleaner With Water

WARNING: You must always inspect your Pistol Grip prior to each use to ensure both O-Ring seals are present (see figure right). Do not operate if both O-Rings are not present. If you attempt to operate the unit without the O-Rings, there is a risk steam will escape between the Pistol Grip and the attachment that may cause scalding.

Filling Your Canister Vapor Cleaner With Water

Step 1: Before filling the Vapor Cleaner, make sure that the unit is NOT plugged in.

Step 2: Turn Safety/Filler Cap counterclockwise to remove. Note: DO NOT remove the Safety/Filler Cap unless the unit is cool!

Step 3: Using the refill bottle add 1 1/2 quarts of water. Place spout all the way inside unit until water stops. Push to release flow. Do not overfill. Replace Filler Cap by turning clockwise - press down firmly to tighten.

Heating time is approximately 5-8 minutes with cold

water.

Step 4: Plug the unit into a standard 120 volt wall (3-prong) grounded receptacle. The power light will illuminate. Depress On/Off button.

Step 5: Allow approximately 5-8 minutes for vapor unit to reach its working temperature and pressure. When the working temperature has

been	reached, the Green Temperature Ready Light will illumi-
nate and the unit	is ready to operate.

Step 6: Connect desired attachments into the Flexible Vapor Hose.

Note: After you start using vapor, the Green Temperature Ready Light will turn on and off intermittently, indicating that vapor is being produced. However, vapor can be continuously used.

Step 7: At the start, some water will come out from the nozzle of the attachment. This is unheated water in the hose and is normal.

IMPORTANT: When the Vapor Cleaner has run out of water, the low-water thermostat will switch off the unit. The heater will NOT turn on again until the boiler has cooled or has been refilled with water again.

IMPORTANT: The “On/Off” button only provides power to the Vapor Generator Heater and the “On” / “Ready” lights. The Handle Vapor Switch

is electronic and receives power directly from the wall plug outlet.

WARNING: When refilling the Vapor Cleaner while it is still hot, the first drops of water might bubble up. Use caution when opening the Safety/Filler Cap. Do not open while hot! Leave the unit plugged in, press the “On/Off” button to “Off”, then depress Handle Switch only to “On” position and leave “On” for 10 minutes to relieve Vapor

5