Refilling Your Canister Vapor Cleaner With Water
Step 1: Press On/Off Button to turn the unit “Off”. Depress the Vapor Switch only on the Pistol Grip to “On” and leave “On” for 10 minutes to ensure that any remaining pressure in the boiler has been released.
Step 2: Depress the Vapor Switch on the Pistol Grip to the “Off” position and disconnect Electrical Power Cord from wall outlet.
Step 3: Wait an additional 10 minutes before opening the Safety Cap. Carefully loosen the Safety/Filler Cap by rotating counterclockwise. Any residual steam will be released below the Safety/Filler Cap if the tank has not been completely vented. When the hissing stops and the last of the vapor has been released, remove the filler cap.
Step 4: Allow the vapor cleaner to cool for
Step 5: Refill water tank with water using the Refill Bottle, as previously described.
Step 6: Firmly screw the Safety Filler Cap back onto the Vapor Cleaner by turning clockwise and pressing down lightly.
Step 7: Connect power cord to the wall outlet. Press the On/Off Power Switch and wait until the Temperature Ready Light comes on before you continue cleaning.
WARNING: If you attempt to refill the machine while the Vapor Generator is still hot, there is a risk that water will be squirted back during filling and cause scalding. Extreme care should be taken when refilling the unit.
Using Your Canister Vapor Cleaner with Floor Brush
Step 1: Connect one of the Extension Tubes to the Pistol Grip on the Flexible Vapor Hose. To insert the Extension Tubes one onto the other or onto the Pistol Grip, press the button ensuring that it fits into the hole. To disconnect, repeat the operation by pressing the button and pulling the two pieces apart.
6
