Celoc® Hypo-Allergenic Filter System
The CELOC SMMS outer bag of your vacuum cleaner is high filtration medical material designed to filter the smallest of dust particles. It is important that the inside of the outer bag be cleaned. Turned inside out, vacuum the inside of the outer bag or hand wash, with warm water and air dry. For best results, the CELOC SMMS outer bag should be replaced once a year. The CELOC layered disposable inner dust bag must be replaced once a month even if it is not full. Change it more often if it is used in extremely dirty areas. Increase the cleaning power of your vacuum by changing the bag often.
Operating Instructions for the Radio Handle
ON/OFF SWITCH: Located on headphone cord. Controls power to the headphone.
VOLUME: Located on headphone cord.
Adjust volume by turning dial.
WARNING: Do not press panel buttons with finger nails. Damage can occur. Use finger surface only.
POWER INDICATOR: Lights when power is present.
SCAN BUTTON: Searches to the next available station signal.
RESET BUTTON: Returns station signal search to beginning of FM frequency range. RESET must be pressed to restart a station signal scan.
HEADPHONES: Insert headphone jack here.
Troubleshooting Guide
WARNING: Unplug cord from electrical outlet before servicing.
SAVE SERVICE CALLS...CHECK THESE FIRST:
•Is the disposable filter dust bag full?
•Are pores of filter dust bag clogged with powder or fine dust?
•Is anything clogging the revolving brush, lower tube, intake opening, fan housing or connector assembly opening?
•Is the belt in place and turning the brush?
•Are the brush ends in the proper location?
•Does the brush turn freely? Are hair, string or rug fibers wound around the brush?
PROBLEM | POSSIBLE SOURCE | AREAS TO CHECK |
CLEANER | Not plugged in | Be sure cleaner is |
WILL NOT RUN | properly. | firmly plugged |
|
| into wall outlet. |
| No electricity in | Check electrical |
| wall outlet. | |
|
| circuit breaker. |
| Plug not firmly in | Plug firmly in |
| handle assembly. | handle assembly. |
|
|
|
CLEANER | Filter bag is full. | Replace filter bag. |
DOES NOT PICK UP |
| See “To Install |
|
| Paper Filter Dust |
|
| Bag.” |
| Nozzle or intake | Clear obstruction. |
| pivot clogged. |
|
| Belt is broken or | Replace belt. |
| stretched. |
|
| Brush is worn. | See “To Adjust |
|
| or Replace Brush.” |
| Bag tube clogged. | Clear obstruction. |
| Bag pores are | Change bag. |
| clogged with fine |
|
| dust. |
|
| Impeller fan is | Return to Service |
| broken. | Center for repair. |
| Revolving brush is | Check brush roll |
| not even at both | end cards. Make |
| ends. | sure words “old” |
|
| or “new” match at |
|
| each end. |
|
|
|
ALL OTHER SERVICING SHOULD BE DONE BY AN ORECK AUTHORIZED SERVICE CENTER.
CALL CUSTOMER SERVICE HOT LINE
US: 1-800-989-3535
CANADA:
Whenever calling, please be sure to have your model and serial number from data plate.
6
