Oregon ATC-2K VI Quick Start, Battery Installation, Turning the Camera On, Turning the Camera Off

Models: ATC-2K

1 17
Download 17 pages 54.59 Kb
Page 7
Image 7
VI) Quick Start

VI) Quick Start

Battery Installation

Be careful!! The edge of the base clip is sharp, when unscrewing the cover, make sure the clip is in the same direction as the lens. Observe the following precautions when unscrewing the cover of the camera:

1. Unscrew the cover at the end of the unit. 2. Place your finger on the 'lip', which is on the bottom half of the rear of the unit, and pull in an upward

direction to open the battery slot door. 3. Insert 2 x AA alkaline batteries into the battery slot

with the polarity in the direction as shown.

4. Close the battery slot door and screw on the end of unit cover.

Important: When the battery is low, the low battery icon will appear on the LCD display.

Always upload video footage to your PC prior to replacing batteries to avoid memory loss

Note:Battery InstallationTurning the Camera OnTurning the Camera OffManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual background a) Battery installation should be done under adult supervision. Manual background b) Do not mix old and new batteries together. Replace Manual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual background

both batteries at the same time. c) Remove the batteries if the camera is not going to be used for long periods of time. This will save battery

11 life.

d)Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. Only batteries of the same or equivalent type as recommended are to be used together.

e)Non-rechargeable batteries are not to be recharged.

f)Rechargeable batteries are to be removed from the camera before being charged.

g)Rechargeable batteries are only to be charged under adult supervision.

h)Exhausted batteries are to be removed from the camera.

i)The supply terminals are not to be short-circuited.

Turning the Camera On

Press and hold the Manual background for 2 seconds (two beeping sounds). The LCD display will light up.

For your safety, do not press any buttons on the camera during sports activities.

Turning the Camera Off

1. Press and hold the Manual background for 2 seconds (two beeping sounds). The LCD display will turn off.

2. The camera will be turned off automatically after 30 minutes of not being used unless it is in USB mode.

Manual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual background12Manual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual background

Page 7
Image 7
Oregon ATC-2K technical specifications VI Quick Start, Battery Installation, Turning the Camera On, Turning the Camera Off