Batteries
NOTE When using the product for the first time, please note that the batteries have already been installed in the unit. To operate, locate the clear plastic battery tab inside the battery compartment and remove it.
To load the batteries:
Diagram | Instructions |
| 1. Locate the battery compartment. |
2.Install the batteries by matching the correct polarity.Alwaysuse thecorrect batterytype (2
Warning: Reversing the polarity may damage the product.
NOTE Replace the batteries whenever the weak battery mark ( 
) is shown, the display is dim, or the display does not illuminate when the power is on. Replace all the batteries at the same time - it is dangerous to mix old and new batteries.
Contact your local waste disposal authority for instructions on how to dispose of used batteries. Used batteries can be harmful to the environment, and should not be thrown out with household trash.
EN
Placement of Unit
You can either mount the main unit on a wall or make it stand on a flat surface.
Method | Instruction | Diagram |
Table | The unit is already equipped with a Table |
|
Stand | Stand. Simply pull out the Table Stand |
|
| and rest the main unit on a flat surface. |
|
Wall | The main unit can be mounted onto a wall |
Mount | using a No. 6 screw (3.0mm). |
| a) Position and nail the screw into the |
| place where you would like to hang |
| your main unit. |
| b) Leave ample space between the wall |
| and the screw head while testing to |
| make sure the nail is secure. |
| c) Fit the unit’s |
| onto the screw head. |
5
JM889NA ENG R3 | 5 | 12/16/04, 5:04 PM |
