Oregon RA129 user manual Altimo

ALTIMO

Digital Altimeter Watch

Model: RA129

USER MANUAL

EN

INTRODUCTION

Thank you for selecting the Oregon Scientific™ ALTIMO Digital Altimeter Watch (RA129). Equipped with real- time clock, stopwatch, alarm, backlight and keypad lock functions, this watch can also be used for providing daily altitude reading.

IMPORTANT

•The measurement functions built into the RA129 are not meant to substitute professional measurement or industrial precision devices. Values produced by this device should be considered as reasonable representations only.

•Oregon Scientific™ assumes no responsibility for any loss, or any claims by third parties that may arise through the use of this device.

CONTROL BUTTONS

1 3

4

2 5

1.MODE: Switch to another display; quick exit during any setting mode

2.SET: Enter setting mode; confirm setting value

3.ST / SP / + : Increase value of the setting; start / stop stopwatch

4. / : Activate backlight; lock keypad

5.RST / -: Decrease value of the setting; reset stopwatch

LCD

1
2
3	5
4				6
		7
			8

1. : Indicates beep tone is turned Off

2. : Indicates keypad is locked

3.Displays altitude trend bar chart

4.Displays clock, calendar, stop watch, alarm time, altitude or mode banners

5. : Indicates alarm is On

6. : Indicates stopwatch is displayed or running

7. : 12 hour clock, altitude unit

8. or : Indicates battery power is low

GETTING STARTED

TURN ON DEVICE (FIRST-TIME USE ONLY)

Press any key for 2 seconds to activate the LCD display.

BATTERY REPLACEMENT

The RA129 uses a CR2032 3V battery, which has already been installed. See below for battery warnings.

INDICATION	DESCRIPTION
	The battery is low.
	The battery is too low to operate.
	The altitude trend bar chart is
	cleared.

NOTE While the low battery icon is displayed, altitude reading, alarm beeping and backlight are disabled. It will return to normal once battery has been replaced.

NOTE If you need to replace the battery, we highly recommend you to contact the retailer or our customer service department.

To replace the battery:

1.Use a small Phillips screwdriver to remove battery compartment lid. Once opened, please keep the screws in a safe place to avoid losing them.

2.Remove the old battery and insert the new one, matching the polarities.

3.Replace the lid by screwing it back into place using a

Phillips screwdriver.

OPERATING MODES

Press MODE to switch between:

•Time Mode

•Date Mode

•Altimeter Mode

•Chrono (Stopwatch) Mode

•Alarm Mode

TIME MODE

This mode is used for viewing the current time and altitude trend bar chart and for setting the time and date.

TO SET TIME AND DATE

1.Press MODE to navigate to Time Mode.

2.Press and hold SET to enter settings.

3.Press ST/SP/+ or RST/- to change values of the setting. Press and hold ST/SP/+ or RST/- to rapidly change values.

4.Press SET to confirm and move to the next setting.

Repeat steps 3-4 for each setting option. The setting options are as follows: 12 / 24-hour time; hour; minute; year; month-day / day-month; month; day; altitude unit (m / ft); beep on/off.

5.Press MODE anytime to confirm and exit settings.

DATE MODE

This mode is used for viewing the current date and altitude trend bar chart. Press MODE to navigate to Date Mode.

ALTIMETER MODE

This mode is used for viewing the current altitude reading. Press MODE to navigate to Altimeter Mode.

TO SET THE ALTITUDE

For the purpose of accuracy, users are recommended to manually adjust and set the altitude. The corresponding sea level pressure will be automatically updated.

1.Press MODE to navigate to Altimeter Mode.

2.Press and hold SET to enter settings.

3.Press ST/SP/+ or RST/- to change values of the setting. Press and hold ST/SP/+ or RST/- to rapidly change values.

4.Press MODE to confirm and exit.

ALTITUDE TREND BAR CHART

This bar chart displays the altitude reading of the passed 7 minutes, with the altitude represented by 5 rows (1 row = 10 m or 32.8 ft) and the 7 minutes represented by 7 columns (1 column = 1 min).

The latest reading is displayed at the last column on the right and is always positioned at the 3rd row. This is to allow other columns to adjust their height correlative of the latest reading.

ALTITUDE OUT OF RANGE

When the altitude is out of range, “HIGH” and “LOW” will be displayed until the altitude is within range again.

when the altitude is above the maximum value

when the altitude is below the minimum value

NOTE When the altitude is out of range, the last column on the right will become blank until the altitude is within range again. All the other columns will adjust their height to reflect the latest reading.

STOPWATCH MODE (CHRONO)

TO START / STOP STOPWATCH

1.Press MODE to navigate to Chrono Mode.

2.Press ST/SP/+ to start / stop stopwatch.

TO RESET STOPWATCH

Press RST/- to reset stopwatch.

NOTE Stopwatch can be reset to 00:00:00 only if it has been stopped or paused.

ALARM MODE

TO SET ALARM

1.Press MODE to navigate to Alarm Mode.

2.Press and hold SET to enter settings.

3.Press ST/SP/+ or RST/- to change values of the setting. Press and hold ST/SP/+ or RST/- to rapidly change values.

4.Press SET to confirm and move to the next setting.

Repeat steps 3-4 for each setting option. The setting options are as follows: hour; minute.

5.Press MODE anytime to confirm and exit settings.

TO ACTIVATE / DEACTIVATE ALARM

1.Press MODE to navigate to Alarm Mode.

2.Press ST/SP/+ or RST/- to activate / deactivate alarm. indicates that the alarm has been activated.

3.Press MODE to confirm and exit.

TO SILENCE ALARM

When the alarm clock is activated, it will sound at the set time every day. Press any button to stop the alarm for that day.

NOTE The alarm clock is still active and will set off again the following day.

BACKLIGHT AND KEYPAD LOCK

To activate backlight:

Press / to turn backlight On for 5 seconds.

NOTE The backlight function will not operate if “ ” or

“ ” is displayed.

To toggle keypad lock On or Off:

Press and hold / for 2 seconds. indicates keypad is locked.

USE IN THE WATER

The RA129 is water-resistant up to 30 meters (98 feet).

	RAIN	SHOWERING	LIGHT	SHALLOW	SNORKELING/
	SPLASHES	(WARM /	SWIMMING /	DIVING /	DEEP
	ETC	COOL	SHALLOW	SURFING /	WATER
		WATER	WATER	WATER	DIVING
		ONLY)		SPORTS
30M /	OK	NO	NO	NO	NO
98 FEET

NOTE Set the watch before exposing it to excessive water. Pressing the keys while in the water or during heavy rainstorms may cause water to enter the watch.

SPECIFICATIONS

Real time clock	12/24 format with hour / minute /
	second
Stopwatch	00:00:00 to 99:59:59 (hr:min:sec)
Altitude range	-400 m to 9000 m
	(-1312 ft to 29520 ft)
Altitude refresh rate	20 sec
Altitude trend bar	1 min
chart refresh rate
Power	1 x CR2032 3V battery

PRECAUTIONS

To ensure you use your product correctly and safely, read these warnings and the entire user manual before using the product:

•Use a soft, slightly moistened cloth. Do not use abrasive or corrosive cleaning agents, as these may cause damage. Use lukewarm water and mild soap to clean the watch. Never use the products in hot water or store them when wet.

•Do not subject the product to excessive force, shock, dust, temperature changes, or humidity. Never expose the product to direct sunlight for extended periods. Such treatment may result in malfunction.

•Do not tamper with the internal components. Doing so will terminate the product warranty and may cause damage. The main unit contains no user-serviceable parts.

•Do not scratch hard objects against the LCD display as this may cause damage.

•Take precautions when handling all battery types.

•Remove the batteries whenever you are planning to store the product for a long period of time.

•When replacing batteries, use new batteries as specified in this user manual.

•The product is a precision instrument. Never attempt to take this device apart. Contact the retailer or our customer service department if the product requires servicing.

•Do not touch the exposed electronic circuitry, as there is a danger of electric shock.

•Check all major functions if the device has not been used for a long time. Maintain regular internal testing and cleaning of your device. Have your watch serviced by an approved service center annually.

•When disposing of this product, ensure it is collected separately for special treatment and not as normal household waste.

•Due to printing limitations, the displays shown in this manual may differ from the actual display.

•The contents of this manual may not be reproduced without the permission of the manufacturer.

NOTE The technical specifications for this product and the contents of the user manual are subject to change without notice.

NOTE Features and accessories will not be available in all countries. For more information, please contact your local retailer.

ABOUT OREGON SCIENTIFIC

Visit our website (www.oregonscientific.com) to learn more about Oregon Scientific products. If you’re in the US and would like to contact our Customer Care department directly, please visit: www2.oregonscientific.com/service/support

OR

Call 1-800-853-8883.

For international inquiries, please visit: www2.oregonscientific.com/about/international

EU-DECLARATION OF CONFORMITY

Hereby, Oregon Scientific, declares that this ALTIMO Digital Altimeter Watch (Model RA129) is in compliance with EMC directive 89/336/CE. A copy of the signed and dated Declaration of Conformity is available on request via our Oregon Scientific Customer Service.