Oregon Scientific atc-2k manual VI Quick Start, Battery Installation, Turning On the Camera

Models: atc-2k

1 18
Download 18 pages 10.1 Kb
Page 8
Image 8
VI) Quick Start

VI) Quick Start

Battery Installation

1.Turn and pull to release the cover at the end of the unit.

2.Release the battery tray by pushing the release hook

with a pen or similar object.

3.Insert 2 x AA alkaline batteries into the battery tray with the polarity in the direction as shown.

4.Replace the tray and cover.

Be careful!! The edge of the clip is sharp, when turning and pulling the cover, make sure the clip is in the same direction as the lens. Observe the following precautions when turning and pulling the cover of the camera.

Important: When the camera is low in battery, the low battery icon will appear on the LCD display.

Always download video footages to your PC prior to replacing batteries to avoid memory loss.

Note:

a)Battery installation should be done under adult supervision.

b)Do not mix old and new batteries together. Replace

all the batteries at the same time.

c) Remove the batteries if the camera is not going to be used for long periods of time. This will save battery

11life.

d)Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. Only batteries of the same or equivalent type as recommended are to be used.

e)Non-rechargeable batteries are not to be recharged.

f)Rechargeable batteries are to be removed from the camera before being charged.

g)Rechargeable batteries are only to be charged under adult supervision.

h)Exhausted batteries are to be removed from the camera.

i)The supply terminals are not to be short-circuited.

Turning On the Camera

Press and hold the Battery Installation for 2 seconds (two beeping sounds). The LCD display will light up.

For your safety, do not press any buttons on the camera during sports activities.

Turning Off the Camera

1. Press and hold the Turning On the Camera for 2 seconds (two beeping sounds). The LCD display will turn off.

2. The camera will be turned off automatically after 10 minutes of not being used unless it is in USB mode.

12

Page 8
Image 8
Oregon Scientific atc-2k manual VI Quick Start, Battery Installation, Turning On the Camera, Turning Off the Camera