Oregon Scientific BAR628HG / BAR628HGU user manual Getting Started, Remote Sensor THGR122NX

EN

GETTING STARTED

BATTERIES

Batteries are supplied with this product:

Main unit 3 x UM-3 (AA) 1.5V batteries

Remote unit 2 x UM-4 (AAA) 1.5V batteries

Insert batteries before first use, matching the polarity (+ and -) as shown in the battery compartment. For best results, install batteries in the remote sensor before the main unit. Press RESET after each battery change.

NOTE Do not use rechargeable batteries.

shows when batteries are low.

NOTE It is recommended that you use alkaline batteries with this product for longer performance.

	UNIT		LOCATION
	Main	Indoor Temperature /
		Humidity Area
	Remote	Outdoor Temperature /
		Humidity Area
Installing the batteries:

CHANGE SETTINGS

To change, time, calendar and language settings:

1.Press and hold MODE for 2 seconds to enter setting mode.

2. Press or to change settings. (To reach the setting you want quickly, press and hold or .)

3. Press MODE to confirm.

TABLE STAND OR WALL MOUNT

Use the stand on the back of the main unit / remote sensor, or mount it on a wall with a nail.

To attach the main unit stand:

To use the main unit wall mount:

To use the remote sensor stand or wall mount:

REMOTE SENSOR (THGR122NX)

This product is shipped with a THGR122NX Thermo / Hygro Sensor that collects Temperature and Humidity data. Data can be collected from up to 3 sensors. Additional sensors sold separately.

SETUP SENSOR

1.Open the remote sensor battery compartment with a small Phillips screwdriver.

2.Insert the batteries, matching the polarity (+ and -) as shown in the battery compartment.

SWITCH	OPTION
Channel	Channel 1-3. If you are using more than
	one sensor, select a different channel for
	each sensor.

4