Oregon Scientific RM888PA Before You Begin, Power, How To Activate The Back-Light, J. Focus Knob

J.[FOCUS] KNOB

Adjusts the focus of projection

K.7.5 V DC JACK (with rubber-cover attached) For AC power adapter installation

BEFORE YOU BEGIN

In order to operate this unit slide the [LOCK] to the left. This will unlock the key-operation and expose the projection lens.

unlock lock

DC 7.5V

POWER

This unit can be either operated by batteries or AC power or with both AC power and batteries.

DC 7.5V

GB

Battery Installation:

1.Remove the battery compartment door.

2.Insert two AAA-sized (UM-4) 1.5V batteries as shown.

3.Press RESET.

4.Replace the battery compartment door.

When the battery power level is low, the analog clock display will start to blink. Replace the batteries or connect it with AC power adapter and press RESET.

This unit is equipped with a short-term power back-up feature. It can still operate for a short period of time even after it has been disconnected from the power supply. Therefore, all settings can be saved during battery replacement. During this period, the analog clock display will also blink. In this case, replace the batteries or connect it with AC power adapter .

Note: Under normal circumstances, the batteries are good for 1 year. However, the battery life can be vastly reduced by frequent use of the projector or snooze function.

If not disposed of properly batteries can be harmful. Pro- tect the environment by taking the exhausted batteries to authorized disposal stations.

HOW TO ACTIVATE THE BACK-LIGHT

Press [SNOOZE/] to turn on the back-light for 5 seconds.

3