EN
If no signals are received, blanks
kinetic wave icon will show " 
". Press [CHANNEL] and [MEMORY] simultaneously to enforce another search for about 30 seconds. This is useful in synchronizing the transmission and reception of the remote and main units.
Repeat this step whenever you find discrepancies between the reading shown on the main unit and that on the corresponding remote unit.
HOW TO CHECK REMOTE AND
INDOOR TEMPERATURES
The indoor temperature is shown on the second line of the display.
As for the remote sites or channels, press [CHANNEL] to go from one channel to another. The kinetic wave display on the channel number indicates if the reception of that particular channel is in good order.
If no readings are received from one particular channel blanks
If the temperature goes above or below the temperature measuring range of the main unit or the remote unit (stated in specification), the display will show “HHH” or “LLL”.
TEMPERATURE TREND
The temperature trend indicator on the screen shows the trend of samplings collected at that particular remote site. Three trends, rising, steady and falling, will be shown.
Arrow |
|
|
| |
indicator |
|
|
| |
Temperature | Rising | Steady | Falling | |
Trend | ||||
|
|
|
MAXIMUM AND MINIMUM
TEMPERATURES
The maximum and minimum recorded indoor temperatures and those of outdoor channels will be automatically stored in memory. To display them:
1.Select the channel to be checked.
2.Press [MEMORY] once to display the maximum temperature and again the minimum temperature. The respective indicators, MAX or MIN will be displayed.
To clear the memory, hold down [MEMORY] for two seconds. The maximum and minimum temperatures will be erased. If you press [MEMORY] now, the maximum and minimum temperatures will have the same values as the current ones until different readings are recorded.
6
RMR182_EN | 6 | 8/16/04, 2:58 PM |
