Oricom ECO90 manual From HANDSETS 2ECONNECT After TMINUTES

28TROUBLESHOOTING GUIDE

Problem	Possible cause(s)	Solution(s)
"ADAAUDIOAQUALITYO	1. Interference from nearby electrical appliance.	1. Try a different connection point, one that is away from other
(crackles,echo, etc.).	2. Base unit is installed in a room with thick walls.	electrical appliances.
	3. The handset is too far from the base unit.	 )NSTALLTTHELBASE UNITEIN A $)&&%2%.4 ROOMT/2 USE
	 )F YOU HAVEE"ROADBAND!$3, YOU NEEDNAEIN LINEA	EXTENSION leads.
		 -OVEE#,/3%2 TO3THE2BASE UNIT
	filter (not supplied).
		 %NSURE A INLINE !$3,NlLTERIIS INSTALLED ON ALLLPHONERSOCKETST
		between wall plate and your phone.
#ALLER )$EDOES NOT WORK	Service not activated.	#HECKKYOURU35"3#2)04)/. WITH)THE43%26)#% PROVIDER
Phone does not ring when	1. The ringer is off.	1. Turn ON the ringer.
a call comes in.	2. Too many phones are sharing the same phone	 $ISCONNECT SOMEEOF THE PHONESEFROM THE PHONE LINE
	line.	3. Check base unit CONNECTIONS.
	3. Base unit not plugged in.
Keypad does not work.	Keypad may be locked.	UNLOCK the keypad.
Busy tone + in use light on.	1. Other handset may still be connected.	 #HECKK!,,!HANDSETS AND %.$ ALL CALLS
	2. Check power supply connection.	2. Check CONNECTIONS to wall and base.
Handset registration fails	The base memory may be full.	$ELETE UNUSED HANDSET AND TRYYAGAIN
continuously.
#ANNOT MAKEANSWERRA ND	2nd call service can be activated.	Check with your service provider. Check the recall selection is
call		correct.

Note:

If none of the above solutions help, reset your phone by disconnecting the mains power from the base and removing batteries

FROM HANDSETS 2ECONNECT AFTER TMINUTES