Key Beep
When the key beep is turned on, you will hear a tone whenever you press a key on the handset. You have the option of turning on or off the key beep.
1.Press 2 once you have entered into programming mode.
2.Only the
icon turns on. The screen displays the current setting. “1” means the key beep is currently off, “2” means it is currently on.
3.Press 1 to turn off the key beep. Press 2 to turn it on.
4.Press 
to confirm and return the phone to standby.
Recall Timing Duration
Recall timing default settings are; Australia 100ms and New Zealand 600ms. You should not need to change these settings.
If when you are using network services or a PBX the 
button does not work you can select a different setting.
1.When the phone is in standby mode press 
to enter programming mode.
2.Press 3 the 
icon turns on.
3.The screen displays the current setting, “1” short (100ms) duration or “2” long (600ms) duration.
4.Press 1 or
2 to change the duration.
5.Press 
to confirm change and return to standby.
OTHER FEATURES
Shortcut to Turn Ringer On/Off
You can use this shortcut to turn on/off the handset ringer when the
phone is in standby. Simply press and hold 
the 
icon turns on whenever the ringer is turned off. Ensure you turn the ringer back on later or you will not hear incoming calls.
Key Lock
Press and hold 
during Standby to lock or unlock the keypad. The 
icon turns on whenever the keypad is locked.
When the keypad is locked, pressing any key will have no effect during
standby (except holding 
.) When there is an incoming call, you can
still answer the call by pressing 
. During the call, the keypad
13 of 16
functions as normal. When the call is ended, the keypad will be locked again.
Base Ringer Volume
Pressing and holding 
on the base adjusts the base ringer volume. The ringer will be played once at the new volume level. If the ringer is turned off, you will hear two short beeps.
You cannot change the base ringer setting when you are talking on the phone.
Finding (Paging) the Handset
You can page or locate the handset by simply pressing 
on the base. The handset produces a tone for 30 seconds and the handset display flashes “oooo”. You can stop the paging by pressing any key on the handset.
One Touch access to Telstra® Home Messages 101 (Australia Only) If you have activated Telstra’s Home Messages 101 you can check if you have messages. This service is free to turn on from most phones in Australia.
1.Press and hold 0 for 2 seconds in standby mode.
2.The phone will automatically go
number.
For more information contact Telstra.
Out of Range Warning
When you are talking on the phone and you walk too far away from the base, you will hear an alert tone through the earpiece. You should walk back closer to the base. Failing to do so will result in the call being disconnected.
If you do not see the
icon on the display, the handset is not linked to the base.
Returning phone to Default Settings
If you wish to reset the handset back to its original settings it can be done as follows.
1.Once you are in programming mode, press and hold 
until you hear the confirmation tone.
2.The handset settings will be reset and the phone returns to standby. Note: This action clears all the numbers in redial, phonebook and CID log.
14 of 16
