Oricom TP88 manual Using the Handset Volume Control, Last Number Redial

Using the Handset Volume Control

You can adjust the volume level of the handset receiver by adjusting the volume control on the side of the handset during a conversation. There are two levels to adjust between: Normal and Loud (NORM-LOUD).

Last Number Redial

The TP88 will store the last 16 numbers you called. These are redialled as follows.

1.To redial the last number leave the handset on the base, press REDIAL repeatedly until you find the number you wish to dial.

2.When you find the number you wish to dial press the SPEAKER button or pick up the handset. The number will now dial.

Saving Numbers to One-Touch Memory (M1 to M4)

Note: When storing memory numbers, your phone must have batteries installed.

NUMBERS ONLY CAN BE STORED IN THESE MEMORIES.

1.With the phone on-hook, Dial the number you wish to dial (up to 16 digits) using the dial pad.

2.Then press the STORE button

3.Press the one-touch memory button that you wish to store the number in ([M1], [M2], [M3] or [M4]). The number is now stored.

4.Repeat steps 1 to 3 to store other numbers.

Saving Numbers to Two-Touch Memory (MEM 0 to MEM #)

1.Dial the number you wish to dial (up to 16 digits) using the dial pad.

2.Press the STORE button once.

3.Press any number on the dial pad that you wish to store the number in ([0] to [#]). The number is now stored.

4.Repeat steps 1 to 3 to store other numbers.

Note: There is a time-out for storing numbers. If the TP88 times out before the number is stored, try again.

MEMORY D AL NG

Making Calls from the One-Touch Memory

Follow the instructions below to dial a number from the one-touch memory:

1.Pick up the handset, or press the SPEAKER button to get a dial tone.

2.Press the memory number ([M1], [M2], [M3] or [M4]] button where the number is stored.

3.The number will be displayed and your call will be automatically dialled exactly as you programmed.

8