Oster 128263, 6079 user manual Cleaning Your Countertop Oven, Storing Your Countertop Oven

Cleaning Your Countertop Oven

Step 1. Turn all knobs to off position then unplug unit and let it cool.

Step 2. Wipe unit down with damp cloth. *DO NOT IMMERSE IN WATER.

Make sure to only use mild, soapy water. Abrasive cleaners, scrubbing brushes and chemical cleaners will damage the continuous clean coating on this unit.

Step 3. Remove crumb tray by pulling out of Countertop Oven.

Step 4. Shake off crumbs from crumb tray. Cleaning the crumb tray often will avoid any accumulations.

Step 5. Remove wire rack and clean with damp cloth or place in top rack of dishwasher.

Storing Your Countertop Oven

Allow the appliance to cool completely before storing. If storing the Countertop Oven for long periods of time make certain that the Countertop Oven is clean and free of food particles. Store the Countertop Oven in a dry location such as on a table or countertop or cupboard shelf. Wind the electrical cord around the cord storage brackets. Other than the recommended cleaning, no further user maintenance should be necessary.

Helpful Tips / Troubleshooting

Problem	Potential Cause	Solution
• Overcooked /	• Incorrect temperature or	• You may have to adjust the time
Undercooked Foods	time setting	and temperature to desired taste.
		• Because your Countertop Oven is smaller than
		your regular oven, it will heat up faster and
		generally cook in shorter periods of time.­
	• Rack placement	• Refer to “Positioning Rack” Section, Page 4.
• Burnt Smell	• Food build-up inside oven,	• Refer to “Cleaning Your Countertop Oven”
	on heating elements or in	Section, Page 7.
	crumb tray.
• Oven does not	• Unit is unplugged	• Plug the Countertop Oven into a 120-volt AC
turn ON		electrical outlet.
	• Timer was not turned	• Set timer knob and temperature knob to desired
	past 20 minute mark.	setting. Both must be turned on to operate the
		Countertop Oven.
• Only one heating	• Function setting selection	• Check to see if Broil setting is selected
element is heating up	determines which heating
	element will operate.
• Heating elements	• Heating elements will cycle	• Confirm function setting is the correct one
do not stay ON	ON and OFF to maintain	of choice.
	proper heat.

7