Digital Controls
To use the “SPEED” mode:
1.Press the POWER button to turn the product on.
2.Confirm the Blender is set to the “SPEED” Mode - the red indicator light next to “SPEED” will be lit.
3.Press the Arrow “▲– (Up)”“ ▼– (Down)” to switch between speeds.
4.Put the ingredients into the jar.
5.Secure the lid and filler cap.
6.Press the START/STOP button to blend as desired, or you can use the TIMER for up to 60 seconds (see below). Pressing the POWER button stops the motor and turns the blender off.
(Note: This blender is programmed to turn the power off automatically if not used for a period of several minutes.)
To use the “TIMER” mode:
1.Press the POWER button to turn the product on.
2.Set to desired speed, then press the MODE function button until the red indicator light next to “TIMER” is lit.
3.Press the Arrow “▲– (Up)”“ ▼– (Down)” to switch to desired time (in seconds). TIMER goes up to 60 seconds and is in increments of 5 seconds.
4.Press START/STOP to begin blending.
5.Once the program is finished, the product AUTOMATICALLY stops.
Please note: You may press the “START/STOP” button to cancel the program at any time.
To use the “PULSE” mode:
1.Press the POWER button to turn the product on.
2.Press MODE until PULSE red indicator light is lit.
3.Press the Arrow “▲– (Up)”“▼– (Down)” to switch to desired Pulse level.
4.Press and hold down START/STOP button for desired length of time. Release and allow blade to stop. Repeat cycle as desired.
To use the “CRUSH ICE” mode:
1.Press the POWER button to turn the product on.
2.Press MODE until the red indicator light next to “CRUSH ICE” is lit.
3.Press the Arrow “▲– (Up)”“ ▼– (Down)” to switch to desired
4.Crush 6 ice cubes or approximately 2 cups of ice at a time.
5.Secure the lid and filler cap.
5
