| Installation Instructions |
| Model AMP3IC6 |
AMP3IC6 carton includes the following items: | |
1. One (1) each AMP3IC6 | 2.) One (1) each UL Listed Power Supply |
Introduction:
The AMP3IC6 is designed to provide a 6.5 inch speaker that is self powered allowing line input audio that is either balanced or unbalanced to provide the input signal. The power amplifier provides up to 25 watts of power. It has enough power to allow up to four total speakers to be powered by one powered speaker. The additional three can be
Specifications: |
|
Model | AMP3IC6 |
Frequency Response | 50 Hz to 15kHz. HF is optimized to enhance frequency |
| response of the speaker. |
Total Harmonic Distortion (THD) | <.1% |
Signal to Noise Ratio (S/N) | >90dB |
Input Configuration | Differential (noise reducing) |
Minimum Common Mode Rejection | 40dB |
Maximum Power Output | 25watts |
At load impedance | 4 Ohms (2 speakers in parallel or 4 speakers in series |
| parallel) |
Maximum current protected | Yes |
Short Circuit protected | Yes |
One wire to ground protected | Yes |
Minimum Load Impedance | 3.2 Ohms |
Input Load Impedance | 10K Ohms |
Maximum number of Amplifiers on |
|
one line | 50 amplifiers |
Power Supply | 15Volts DC |
Inputs | 3 Balanced Line |
Outputs | 1 Balanced Line, 1 - 25 watt speaker |
Controls | 3 Input level Controls |
| 1 Line out Level Control |
| 1 Amplifier Master Gain Control |
Outputs | 4 Output Jacks allowing automatic correct |
| wiring for series parallel connection by simply plugging |
| each speaker into its jack. |
Heat sink | An oversize |
High Voltage | The highest voltage on the PCB is 15 volts |
Protection | The amplifier is protected against short and overheating |
Plastic | Fire rated |
Available Backcan | UL Listed and Plenum rated, |
| OWI Part# Backcan (Sold Separately) |
Available Tile Bridge (Support Truss) | OWI Part # 6TB (Sold Separately) |
Warranty | 1 year |
Page 4 of 12 | Filename:AMP3IC6 MANUAL |
| 12/08/06 |
