OWI AMP-3IC6 Speaker Specifications Model IC5 Model IC6, Installation, Speaker Placement

IN-CEILING/WALL-MOUNT SPEAKERS

I N S T A L L A T I O N / O W N E R S' M A N U A L

MODEL IC5 / IC6 (NON-AMPLIFIED SPEAKERS)

SPEAKER SPECIFICATIONS:	MODEL IC5	MODEL IC6
System Description	2-Way Co-Axial Speaker	2-Way Co-Axial Speaker
	1/2".Hard Dome Tweeter Ferrofluid	1/2" Hard Dome Tweeter Ferrofluid
High Frequency Driver	cooled	cooled
Low Frequency Driver	5-1/4" Paper Coated Woofer with	6-1/2" Paper Coated Woofer with
	Polyurethane Surround	Polyurethane Surround
Impedance	8 Ohms	8 Ohms
Sensitivity (1 Watt, 1 Meter)	85.2 dB	86.5 dB
Frequency Response	70Hz - 20kHz	45Hz - 20kHz
Power Rating	20 W Nominal, 40 W Max.	25 W Nominal, 50 W Max.
Recommended Amplifier
Power	40 Watts	50 Watts
Dispersion	140o	120o
Size	8" x 2-1/2	9" x 2-1/2"
Cut Out Size	6-5/8"	7-11/16"
INSTALLATION:
Speaker Placement

Before installing your OWI speakers, consider the placement carefully, taking into effect the location of electrical, plumbing and other fixtures.

Placement in Ceiling

OWI speakers should be ideally located above the primary listening area.

Placement in Wall

Optimum sound will be achieved when your OWI speakers are installed at ear level or slightly higher and the listening area is no closer to the speakers than the distance between the speakers themselves.

Mounting your OWI Speakers

Determine the best area to mount your OWI speakers. It will be necessary to run your speaker wires to that location. This location must be free of obstructions, such as electrical conduits, HVAC ducts, or water lines.

Be sure the mounting surface is between 3/8 and 1 1/4 inches thick, and there is at least a 2 3/4 inch clearance behind the mounting surface and no wall studs or other objects block the back of the speaker.

Remove the round cardboard disc from the template supplied and keep it for later use as a paint mask, if you decide to paint your speakers.

Page 9 of 12	Filename:AMP3IC6 MANUAL
	12/08/06