Operations in RGB/YPbPr mode
POWER |
|
| CH |
VOL | VOL |
- | + |
CH
MENUEXIT
Select RGB/YPbPr mode
1 Press the SOURCE button on the unit
or button on the remote control. The screen displays the menu shown as right.
2 Press CH to highlight the RGB or YPbPr item. Press VOL+/- or wait about 4 seconds and the signal source is selected.
C.SYS ZOOM CLK SLP
Auto adjusting
AUTO.ADJ P.M DSP
1 2 3
4 5 6
When VGA signal format is changed or when you switch to RGB mode from another source, the unit adjusts frequency and phase automatically to obtain the best display. During the process of
7 | 8 | 9 | auto correction, the screen |
|
|
| displays Analog RGB Acquiring |
| 0 | Signal, and all buttons on the set | |
|
|
| and on the remote control do not |
|
|
| work until this process is finished. |
|
|
| |
|
|
| When the set displays some nonstandard VGA signals and can |
|
|
| not adjust the picture to the best status by itself, you can adjust it |
|
|
| again by pressing the AUTO. ADJ button on the remote |
|
|
| |
|
|
| control. |
|
|
| NOTE: Please note your final phase and frequency settings as |
|
|
| you might need to |
26