Fire alarm systems
External Fire Brigade
Panel 1828
•Control (key required) and indicating panel for the fire brigade personnel, etc.
•Compact size
Ext. Fire Brigade Panel
This unit (S/W V1.2) is primarily intended to be used by the fire brigade personnel, i.e. for
LEDs, push buttons etc.
The unit has the following LEDs:
•Fire and Alarms queued, indicating
•Operation, indicating that the unit is connected to a c.i.e. and power supplied, i.e. it is in operation.
•Extinguishing, indicating activated output for Extinguishing equipment.
•Ventilation, indicating activated output for Ventilation equipment.
•Fire brigade tx, indicating activated output for Fire brigade tx (routing equipm.).
The unit has the following push buttons:
•Alarms queued, used to scroll amongst the alarms.
•Silence buzzer, used to silence the buzzer (it will
•Silence alarm devices, used to silence the alarm devices (they will
•Reset, used to reset the fire alarms.
The designation texts on the front are in 1828SE in Swedish but a neutral front for other languages is available (1828CC).
Compact size
The compact size enclosure is made of grey high impact ABS. Fitted with a supple- mentary "O" ring gasket, it will comply with IP61, in respect of dust and moisture. A key is required to get access to the push buttons and they are disabled until they are supposed to be used. A key is not required for the alarm presentation and to silence the buzzer. Two compression glands are attached. The unit shall be wall mounted.
SW mode and address setting
The display and the push buttons are used to set the SW mode and address, see the opposite side of this page.
Product application
The 1828 unit is intended for indoor use and in dry premises. SW mode 1826/28 - 1587 is intended to be used in the systems EBL512 and EBL128 SW mode 1826/28 – 1582 in the systems EBL500 / 512 / 1000 / 2000.
Panasonic Electric Works Fire & Security Technology Europe AB Citadellsvägen 23,
Tel: +46 (0)40 697 70 00 • Fax: +46 (0)40 697 70 99