Connections
When connecting the speakers, be sure to use only the optional accessory speakers. Refer to the speaker’s Installation Manual for details on speaker installation.
Speakers (Optional accessories)
Speaker |
terminal (L) |
Speaker |
|
|
| AC cord connection (see page 12) | |
terminal (R) |
| |
– AC cord fixing | ||
1 | 1 Plug the AC cord into | Close |
| the display unit. | Push until |
| Plug the AC cord until it | |
| the hook | |
| clicks. | clicks. |
| 2 Fix the AC cord with the clamper |
|
|
2 | which is attached to the unit. | Open |
|
Note: | For | 2. | Pull off. |
Clampers are not installed to this | |||
Make sure that the AC | unit. Ensure there is sufficient slack | 1. | Keep the |
cord is locked on both | in the AC cord and firmly bind with |
| knob |
the left and right sides. | the supplied cable fixing band, etc. |
| pressed. |
1 |
|
2 | 1 |
| |
| 2 |
Unplug the AC cord
Unplug the AC cord pressing the two knobs.
Note:
When disconnecting the AC cord, be absolutely sure to disconnect the AC cord plug at the socket outlet first.
–Cable fixing band
Secure any excess cables with band as required.
Note:
One fixing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.
Pass the attached cable fixing band through the clip as shown in the figure.
1
To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.
To tighten: | To loosen: |
| Push the catch |
Pull |
|
2 | Pull |
| R AUDIO | L | PR/CR/R PB/CB/B | Y/G |
| AUDIO |
| COMPONENT/RGB IN |
| ||||
|
|
| ||||
SLOT1 | SLOT2 |
| SLOT3 | PC | IN | SERIAL |
Optional Terminal Board Insert Slot (covered)
Dual HDMI Terminals (equivalent of Dual HDMI Terminal Board (TY- FB10HMD)) (see page 11)
COMPONENT/RGB IN andAudio IN Terminals (equivalent of BNC Component Video Terminal Board
From EXTERNAL monitor terminal on Computer (see page 9)
From SERIAL Terminal on Computer (see page 10)
Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
8
