Panasonic AG-1070DC specifications Specifications

SPECIFICATIONS

Model #	AG-1070DC
GENERAL
Power Source	12VDC (Operating Voltage: 10V-16V)
Power Consumption	Approximately 14W
Operating Temperature	+41˚F to 104˚F (+5˚C to +40˚C)
Operating Humidity	35% ~ 80%
Weight	Approximately 11 lbs.
Dimensions (H x W x D)	43⁄4" x 105⁄8" x 139⁄16"
SYSTEM
Television System	EIA standard, NTSC color signal; 525 lines, 60 fields
Video Recording System	2 rotary heads, helical scanning system (VHS mode)
Video Head System	4 rotary heads
Modulation System	Luminance; FM azimuth recording chrominance;
	Converted subcarrier phase shift recording
Audio Track	1 track
TAPE TRANSPORT
Tape Format	VHS tape
Tape Speed	2-hour mode: 15⁄16 ips (33.35mm/s), 6-hour mode: 7⁄16 ips (11.12mm/s)
Recording Time (w/NV-T120)	2-6 hours (VHS mode);
	12-24 hours (linear slow mode)
FF/Rewind Time	Approximately 3 min. w/NV-T120
VIDEO
Video In (BNC)	1.0V p-p, 75 ohms, unbalanced
Video Out (BNC)	1.0V p-p, 75 ohms, unbalanced
Horizontal Resolution	VHS (2-hour mode): 43dB (color), 45dB (monochrome)
AUDIO
Audio In (Phono)	-10dBV, 47K ohms, unbalanced
Mic In (M3)	-60dBV, 600 ohms, unbalanced
Audio Out (Phono)	-8dBV, 1K ohm, unbalanced
Audio Frequency Response	50Hz ~ 10kHz (2-hour mode)
CONNECTORS
Terminal Input	Alarm, alarm reset, summer time
Terminal Output	Tape end, warning
Camera Switching Signal	12V/0V, pulse width: 16.67ms
Remote Control	For AG-A11 (option)

Weight and dimensions shown are approximate. Specifications subject to change without notice.

This product may be subject to export control regulations.

Warning: Unauthorized recording of copyrighted television programs, films, videotapes and other materials may infringe upon the right of copyright owners and be contrary to copyright laws.

1.Audio input/output connectors (phono jacks)

2.Vertical hold controls (2h, 6h) When the image on the TV monitor runs vertically during still-picture playback, adjust these controls by turning them with a small screwdriver.

3.Video input/output connectors Video input/output connectors (BNC); connect the input connector to the video camera, etc. and the output connector to the TV monitor, etc.

4.Camera switching output connector Camera switching output connector; connect it to the sequential switcher.

5.Battery installation area Install the battery in this area.

6.Alarm input connector

Alarm recording input connector; connect it to the external sensor.

7.COMMON terminal

8.Alarm reset connector

Input connector for releasing alarm recording; +4 to +12VDC voltage is required.

9.SUMMER TIME connector

This is used to switch between the present time and summer time.

10.Tape end output connector

When the cassette tape comes to its end during recording, the alarm device installed externally is activated.

11.WARNING output connector

When trouble has occurred in the unit, the alarm device installed externally is activated.

12.Ground terminal

13.12VDC input connector (Caution) When being powered by the car battery, wire the +12V power line using a 5A fuse.

DIMENSIONS

SECTION 1