Emergency Eject

Procedure for removing the tape manually in an emergency

Use the procedure below to remove the cassette tape if it can not be removed even when the EJECT button is pressed.

OBefore proceeding to eject the tape manually, you must first turn off the power to the unit.

1Remove the top panel.

2Use a Phillips head screwdriver to push in and turn the red plastic screw part counterclockwise.

(This screw needs to be rotated about 30 turns before unloading can be started.)

3Insert the take-up jig (packed with the unit) into the tape ejection slot (on the mechanism side of the VTR), and rotate the flange part (white gear) of the supply reel in the take-up direction to take up the tape slack using the rubber part of the take-up jig.

<Note>

Take care not to damage the tape in any way.

4Once more use the Phillips head screwdriver to push in and turn the red plastic screw part counterclockwise. Again rotate the flange part of the supply reel in the take-up direction to take up the tape slack.

This two-step procedure needs to be repeated until the tape is completely housed in the cassette case (about 90 turns of the red plastic screw part).

5Use the Phillips head screwdriver to turn the red plastic screw part at the slot-in side clockwise to eject the cassette tape.

(This screw needs to be rotated through about 140 turns until the tape is ejected.)

<Note>

Take care not to sandwich or catch the tape when closing the cassette cover.

1

5

2

3

4

34

39