-2-
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS!2
+ 1
VTR MULTI
MPX
CABLE
SEL
−20
−60(dB)
AUDIO
LEVEL
INT
PB
EARPHONE
OUT SEL VTR
TRIGGER
ENC
Y/PR/PB
RCU/VTR
SIGNAL
Y/C/B
R/G/B
- 1
+ 2
!1 !0 o i
@4
!6
!7
!8
!9
@0
!5 !3
!4
@3
@2
@1
q
w
e
r
t
y
u
1. Camera Handle
2. Camera Adaptor Holding Screw/knob
The camera adaptor can be removed from the
camera after loosening two knobs on top of the
adaptor and then pressing the release button
underneath of the camera while pulling on rear of
camera adaptor.
3. VTR Start/Stop Button (VTR) (parallel operation)
This button is used to change the recorder mode
from pause (Recording Pause) to recording and
functions in the same way as the VTR Start/Stop
Button on the lens. Press once to start recording.
While recording, the Tally Indicator in the viewfind-
er lights and Tally Light on the viewfinder also
lights.
When the button is pressed once more, the
recorder is set to the Pause mode (Recording
Pause), and the Recording/Tally Indicator and Tally
Light will go off.
4. Intercom/Earphone Level Control
(INCOM EARPHONE)
Use this control to freely adjust the volume level in
the earphone connected to the Earphone Jack (7)
or the headset connected to the Intercom Jack (6).
5. S-Video Output Connector (S-VIDEO OUT)
The luminance (Y) and chroma (C) signals for S-
VHS VTR or monitor are provided at this connector.
6. Intercom Jack (M6) (INCOM)
This jack is used for communication between the
camera operator and operators of Remote Control
Unit (RCU) and Special Effect Generator in the sys-
tem.
7. Earphone Jack (M3) (EARPHONE)
When an earphone is connected, the sound picked
up by the microphone or the played back audio
from a 3/4” U-vision recorder, connected to the
camera through the VTR 14-pin camera connector,
can be monitored. Selection of the audio source is
enabled by the Earphone Out Selection Switch
(10).
8. RCU/VTR Signal Selection Switch
(RCU/VTR SIGNAL ENC, Y/C/B, R/G/B, Y/PR/PB)
This switch selects the video output signal supplied
at the VTR/RCU Connector (18) on the adaptor and
the Red, Green and Blue Output Connectors on the
Remote Control Unit (RCU). The switch has been
set to the R/G/B position at the factory.
ENC:
The composite output signal for the VTR, such
as 1/2” VHS or 3/4” U Machic, is supplied.
Y/C/B:
The chrominance (C) and luminance (Y) sig-
nals are supplied from the R, G and B Output
Connectors for S-VHS format VTR.