17
Troubleshooting
List of Error Codes
0200 Failure Fixed Disk
0210 Stuck key
0211 Keyboard error
*0212 Keyboard Controller Failed
0213 Keyboard locked - Unlock key switch
0220 Monitor type does not match CMOS - Run SETUP
*0230 Shadow RAM Failed at offset :
nnnn
*0231 System RAM Failed at offset :
nnnn
*0232 Extended RAM Failed at offset :
nnnn
0250 System battery is dead - Replace and run SETUP
0251 System CMOS checksum bad - Default configuration used
*0260 System timer error
*0270 Real time clock error
0280 Previous boot incomplete - Default configuration used
0281 Memory Size found by POST differed from CMOS
02B0 Diskette drive A error
02B1 Diskette drive B error
02B2 Incorrect Drive A type - run SETUP
02B3 Incorrect Drive B type - run SETUP
02D0 System cache error - Cache disabled
02F0: CPU ID:
*02F4: EISA CMOS not writable
*02F5: DMA Test Failed
*02F6: Software NMI Failed
*02F7: Fail - Safe Timer NMI Failed
device
address Conflict
Allocation Error for:
device
CD ROM Drive
Entering SETUP ...
Failing Bits :
nnnn
Fixed Disk
n
Invalid System Configuration Data
I/O device IRQ conflict
PS/2 Mouse Boot Summary Screen:
nnnn
kB Extended RAM Passed
nnnn
Cache SRAM Passed
nnnn
kB Shadow RAM Passed
nnnn
kB System RAM Passed
Operating system not found
*Parity Check 1
nnnn
*Parity Check 2
nnnn
Press <F1> to resume, <F2> to Setup, <F3> for previous
Press <F2> to enter Setup
PS/2 Mouse:
System BIOS shadowed
UMB upper limit segment address :
nnnn
Video BIOS shadowed

The following is a list of the messages that BIOS can display. Most of them occur during POST.

Some of them display information about a hardware device, e.g., the amount of memory in-

stalled. Others may indicate a problem with a device, such as the way it has been configured.

If your system displays one of the messages marked below with an asterisk (*), write down the

message and contact Panasonic Technical Support. If your system fails after you make changes

in the Setup menus, reset the computer, enter Setup and install Setup defaults or correct the

error. ( "List of Error Codes")