19
Getting StartedUseful InformationTroubleshootingAppendix
Error Code/Message
Follow the instructions below when an error message or code appears. If the problem persists or if the error code/mes-
sage is not shown here, contact Panasonic Technical Support (Îpage 29).
To start the Setup Utility
ARestart the computer.
BPress
F2
several times while [Panasonic] boot screen is displayed soon after the computer begins the startup
procedure.
Error Code/Message Solution
0211 Keyboard error zDisconnect external keyboard or mouse.
0251 System CMOS
checksum bad -
Default configuration
used
An error has occurred in the memory of Setup Utility settings. This occurs when the memory
content is changed by an unexpected program operation, etc.
zStart the Setup Utility and return the settings to the default values, and then change the
settings as necessary.
zIf the problem persists, the internal clock battery may need to be replaced. Contact
Panasonic Technical Support (Îpage 29).
0271 Check date and
time settings The date and time settings are not correct.
zStart the Setup Utility and set the correct date and time.
zIf the problem persists, the internal clock battery may need to be replaced. Contact
Panasonic Technical Support (Îpage 29).
0280 Previous boot
incomplete - Default
configuration used
Startup has failed repeatedly, so the Setup Utility settings have been returned to the default
values to startup the computer.
zStart the Setup Utility and return the settings to the default values, and then change the
settings as necessary.
Press <F2> to Setup zWrite down the error details and press
F2
to start the Setup Utility. Change the settings if
necessary.
Operating System not
found The operating system is not installed in the floppy disk or the hard disk that you are going to
boot from.
zIf using a floppy disk, change the disk to the one you can use for boot.
zIf using the hard disk, check if the hard disk is recognized in [Information] menu of the
Setup Utility. If the hard disk is recognized, perform the reinstallation (Îpage 17). If not,
contact Panasonic Technical Support (Îpage 29).
zIf a device is connected to the USB port, disconnect the device, or set [USB Port] or
[Legacy USB Support] to [Disable] in [Advanced] menu of the Setup Utility.
RAM Module Failed When the RAM module is not inserted correctly or the RAM module is not conforming to the
computer’s specifications, so a beep will sound and the “RAM Module Failed” message will
be displayed when you turn the power on.
zPress the power button for four seconds or longer to turn off the computer, confirm that
the RAM module conforms to the specifications, and reinsert it.