Connecting/Disconnecting
5 While holding the latch to the right side, slide the lever all the way back. (UNDOCK POSITION)
|
| CAUTION |
|
|
| Do not slide the lever without holding the latch to | |
|
| the right side. | |
6 |
| ||
After confirming that the expansion bus | |||
|
| connector of the port replicator is positioned so | |
|
| that the computer can be docked, insert the front | |
|
| corners of the computer and then press down | |
|
| lightly on the rear corners onto the port replicator | |
E |
| ||
| guide pins. | ||
|
|
|
|
|
|
|
|
7 Confirm that the lever has moved all the way to the front. (DOCK POSITION)
CAUTION
Lever
Latch
(2)
(1)
(1)
Insert the left and right hooks into the computer's locking holes.
Lever 
•Do not attempt to make connections if there is any object between the computer and the port replicator. Doing so could damage the computer and the port replicator.
•Do not attempt to move the port replicator when it is connected to the computer.
•If the computer malfunctions while the port replicator is attached, refer first to the "Troubleshooting" section of the computer's "Operating Instructions". If you still are unable to solve the problem, power off the computer, disconnect the port replicator, connect the AC adaptor to the computer, and check to see if the computer operates normally. If the computer operates normally when the port replicator is not attached, the port replicator may be malfunctioning. Please contact Panasonic Technical Support.
8
