43
Appendix
1
Turn the computer on, and press F2 while [Panasonic] boot screen is displayed.
The Setup Utility will start up.
If a password has been set, enter the Supervisor Password.
You cannot register [Boot] menu with a User Password.
2
Select [Boot] menu, then select [CD/DVD Drive] and press F6 until [CD/DVD Drive] is at
the top of [Boot] menu.
3
Place the Product Recovery DVD-ROM into the DVD-ROM & CD-R/RW drive.
When disk cover does not open:
[CD/DVD Drive Power] has been set to [Off] in the [Main] menu. Perform the following
procedure.
Set [CD/DVD Drive Power] to [On].
Press F10 .
At the confirmation message, select [Yes] and press Enter .
The computer will restart.
Press F2 while [Panasonic] boot screen is displayed.
The Setup Utility will start up.
Set the Product Recovery DVD-ROM, and execute Step
4
.
4
Press F10 .
At the confirmation message, select [Yes] and press Enter .
The computer will restart. If [Enter Password] is displayed during the following procedures, input
the Supervisor Password or the User Password.
This screen should appear.
Regarding backup area
• Requires availability of at least half of the entire hard disk. Without sufficient space
available, the backup area cannot be created.
• When the backup area is created, the usable hard disk capacity will be reduced to less
than half.
• The backup area cannot be accessed from Windows. For this reason, backed up data
cannot be copied to CD-R or other removable disk media.
• When the hard disk backup function is executed, data in the backup area will be over-
written. If newly created or edited data is backed up later, data stored previously
in the backup area will be lost.
NOTE
Create a Backup Area
When dividing the hard disk into partitions
Do not execute [1. [Recovery]] to divide the hard disk into partitions. The hard disk
backup function cannot be enabled after the hard disk has been partitioned. Use proce-
dure
7
to divide the hard disk.
CAUTION
---------------------------------------------------------------------
Select a number
---------------------------------------------------------------------
1. [ Recovery ] Reinstall Windows.
2. [ Erase HDD ] Erase the whole data on HDD for security.
3. [ Backup ] Enable the Backup function.
0. [ Cancel ] Cancel.
---------------------------------------------------------------------
5
Press 3 to execute [3. [Backup]].
6
At the confirmation message, press Y .