21
E
N
G
L
I
S
H
22
E
N
G
L
I
S
H
3332 CQ-C1200U/C1120U/C1110U/C1100U CQ-C1200U/C1120U/C1110U/C1100U

❐General

Power supply: 12 V DC (11 V–16 V), test voltage 14.4 V, negative ground
Current consumption: Less than 2.2 A (CD play mode; 0.5 W×4 channels)
Maximum power output: 50 W×4 channels at 1 kHz, volume control maximum (CQ-C1200U/C1120U)
45 W×4 channels at 1 kHz, volume control maximum (CQ-C1110U/C1100U)
Tone adjustment range:
Bass: ±12 dB at 100 Hz
Treble: ±12 dB at 10 kHz
Suitable speaker impedance: 4–8 Ω
Preamp output voltage: 2.0 V (CD play mode; 1 kHz, 0 dB)
Output impedance: 200 Ω
Sub-Woofer output voltage: 2.0 V (CQ-C1200U)
Sub-Woofer output impedance: 200 Ω(CQ-C1200U)
Dimensions (W×H×D): 7"×115/16"×57/8"(178×50×155 mm)
Weight: 3 lbs. 1 oz (1.4 kg)

❐FM Stereo Radio

Frequency range: 87.9 MHz–107.9 MHz
Usable sensitivity: 11.0 dBf. (1.25 µ
V,
75 Ω)
50 dB quieting sensitivity: 15.2 dBf. (1.6 µ
V,
75 Ω)
Frequency response: 30 Hz–15 kHz (±3 dB)
Alternate channel selectivity: 75 dB
Stereo separation: 42 dB (1 kHz)
Image response ratio: 75 dB
IF response ratio: 100 dB
Signal/noise ratio: 70 dB

❐AM Radio

Frequency range: 530 kHz–1 710 kHz
Usable sensitivity: 28 dB/µV (25 µ
V,
S/N 20 dB)

❐CD Player

Sampling frequency: 8 times oversampling
DA converter: 1 bit DAC system
Error correction system: Panasonic super decoding algorithm
Pick-up type: Astigma 3-beam
Light source: Semiconductor laser
Wave length: 780 nm
Frequency response: 20 Hz–20 kHz (±1 dB)
Signal/noise ratio: 96 dB
Total harmonic distortion: 0.01 % (1 kHz)
Wow and flutter: Below measurable limits
Channel separation: 75 dB
Above specifications comply with EIA standards.
Note:Specifications and the design are subject to modification without notice due to improvements in technology.
Specifications
1
2
1
2
3
4
Switch off the power of the unit.
Remove the removable face plate.
qPress []. The removable face plate will
be opened.
wPush the face plate to either the right or
left.
ePull it out towards you.
Remove the Trim Plate uwith a screwdriver.
qInsert the Dismounting plate ialong
the grooves on both sides of the main
unit until
“
click
”
is heard.
wPull out the unit while pushing the plates
further inside.
Remove the unit by pulling with both hands.
Contact
qPress
uTrim Plate
Screwdriver
iDismounting plate
Insert the tab
end in the
outer groove.
“
Click
”
qInsert
wPull out
w