Preparation
English
98
w
e
q
qPull out the battery
case while pushing the
tab.
wPut a battery in the
case with (+)-side fac-
ing up.
ePut the case back.
Battery Notes
¡Remove and dispose of an old battery immediately.
¡Battery Information:
Battery Type: Panasonic lithium battery (CR2025)
(Included)
Battery Life: Approximately 6 months under normal
use (at room temperature)
¡Do not disassemble or short the battery. Do not throw
a battery into a fire.
¡Keep batteries away from children to avoid the risk of
accidents.
¡Follow local regulations when disposing of batteries.
OFF ACC
IGN
For a ACC-equipped car, select ON. (aPage 17) The
following functions are available. (default: off)
¡The power is turned on automatically when inserting
a disc or magazine.
¡The clock can be displayed even if the power is off.
(aPage 13)
¡After the security function (aPage 17) is set to ON,
the function works when turning the ignition key to
OFF.
¡The unit can be activated just at the push of a button.
: ACC not equipped
(Default)
:ACC equipped
Caution: Improper use of batteries may cause
overheating, an explosion or ignition, resulting in
injury or a fire.
Caution:
Be sure to select OFF when your car has no
ACC position in the ignition switch. Failure
to do this could cause the battery to go
dead.
Notes:
¡Adjust the clock when “NO CT” appears on the dis-
play.
¡When a broadcast of FM Radio Data System is
received, the clock is put right automatically by the
Clock Time service. (aPage 20)
1Select the radio AM mode. (aPage 18)
2Press and hold [DISP] (Display) for
more than 2 seconds.
3Press []]or [[]to adjust the hour.
[[]:Forward
[]]: Back
Press [DISP] (Display) to confirm the
adjustment.
4Press []]or [[]to adjust the minute.
[[]:Forward
[]]: Back
Press [DISP] (Display) to confirm the
adjustment.
The demonstration message appears for first use.
1Press [SOURCE] (PWR: Power).
The demonstration screen appears.
2Press [DISP] (Display).
The demonstration screen is cancelled, and no more
appears.
Note: If you would like to turn on the power and make
the demonstration message appear, hold down
[SOURCE] (PWR: Power)for 4 sec. or more. (at ACC
on) You may need to set the following depending on the
devices to be connected.
Using Subwoofer
¡Subwoofer level adjustment (aPage 15)
¡Subwoofer low pass filter (aPage 15)
¡High pass filter (aPage 15)
The following functions are activated when the Security
Function is ON. (aPage 17)
¡The security indicator lights up when removing the
face plate.
¡The alarm sounds and the message appears on the
screen to warn you to remove the face plate at power
off.
Note: After the ACC setting is set to on, these functions
work when turning the main power off. (aPage 17)
Security Indicator
CQ-C7300N
BAND
Preparation
Battery into Remote ControlACC Setting
Clock adjustment
First Time Power On
(DEMONSTRATION)