Panasonic CT 20SL15 Programming The Remote Control, Programming Without a Code, Component Codes

REMOTE CONTROL OPERATION

Programming The Remote Control

The Universal Remote Control can be programmed to operate many manufacturers’ components, using the com- ponent function buttons for VCR, DVD, CABLE or DBS. Follow the procedures for programming your Remote Control with or without a code for the component.

Device		Operates	Default
TV		￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
VCR
DBS/CBL	￿￿￿		￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
DVD		￿￿￿	￿

Note: Determine the manufacturer of the component and look in the table for the code (found on page 10).

Procedure

1.	Confirm that the external component is plugged in and
	operating.
2.	Turn the component off.
3.	Press ￿￿￿￿￿￿and POWER together, for at least 5 sec-
	onds. After 5 seconds, the illuminated mode (compo-
	nent) buttons will begin to flash. Release the ACTION
	and POWER buttons.
4.	Press appropriate component button on the Remote
	Control VCR, DVD, CABLE or DBS. The component
	button will illuminate steadily and all others will go out.
5.	Enter the 3-digit component code using the Remote
	Control Numeric keypad (0-9). The component but-
	ton will blink twice.
6.	Press the Remote Control POWER to test the compo-
	nent. If the procedure was successful, the component
	will turn on and the component key will blink twice and
	then go out.
Note:	If the component does not operate with the Remote
	Control, repeat steps 3 through 6 using another code

(some brands have multiple codes). If an incorrect code is entered, or if the procedure takes longer than 30 seconds, the programming will fail.

Programming Without A Code

This procedure searches all codes and is called the “se- quence method.”

1.	Confirm that the external component is plugged in and
	on.
2.	Turn the component off.
3.	Press ￿￿￿￿￿￿and POWER together, for at least 5 sec-
	onds. After 5 seconds, the illuminated mode (compo-
	nent) buttons will begin to flash. Release the ACTION
	and POWER buttons.
4.	Press the appropriate component button on the Re-
	mote Control. The component button will illuminate
	steadily and all others will go out.
5.	Press the POWER button to set the remote control into
	the step and set mode.
6.	Point the remote control towards the component.

7.Press VOL (the mode key will blink three times), then press the Remote Control POWER button to test the component. Continue this process until the proper code

is found. If the procedure was successful, the compo- nent will turn on.

Note:	Each time you press the VOL	button, make sure
	that the component key blinks twice before pressing
8.	the POWER button.	￿￿￿￿￿￿	to store the
	Once the device responds, press

code. The mode (component) button will blink twice.

Note: It may take many attempts before the correct code is found. If you miss a code, press VOL, then press the POWER button to test the component.

Component Codes

The Universal Remote Control is capable of operating many component brands after entering a code. Some components may not operate because the codes are not available due to limited memory. The Universal Remote Control does not control all features found in each model.

Write the code numbers from tables in this space. This will serve as a reference if you need to program your Remote Control.

VCR CABLE DVD

DBS

ENGLISH

9