Panasonic CT-27SC15, CT 27SL15, CT 20SL15 manuel dutilisation Installation

Polarized plug

INSTALLATION

Installation

Television Location

Follow these recommendations before deciding the location of your television.

• Avoid excessive sunlight or bright lights, including re-

flections.

• Keep away from excessive heat or moisture. Inad-

equate ventilation may cause internal component fail-

ure.

• Fluorescent lighting may reduce remote control

transmitting range.

Cable / Antenna Connection

For proper reception, either a cable or antenna connection is required.

Cable Connection

Connect the cable supplied by your lo- cal cable company. Tighten with fingers only. Use of any tool (e.g. pliers) for tightening may result in tuner damage.

Incoming Cable from Cable Company

75 Ohm VHF/UHF

on back of TV

• Keep away from magnetic equipment, including mo-

tors, fans and external speakers.

Note: A cable converter box may be required for proper re- ception. Check with your local cable company for com- patibility requirements.

WARNING: Use this television receiver only

with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use cau- tion when moving the cart/apparatus combi-

nation to avoid injury from tip-over. In order to avoid in- jury to children, never place your television receiver on a piece of furniture that is capable of being tilted by a child leaning on it, pulling on it, standing on it, or climbing on it. A falling television can cause serious injury or even death.

Antenna Connections

For proper reception of VHF/UHF chan- nels, an external antenna is required. For best reception an outdoor antenna is recommended.

Note: Cable Mode is preset at the factory. Antenna users must change to TV Mode in the Set Up menu (page 12).

Incoming Cable from

Home Antenna

Optional Cable Connections

Shielded audio and video cables should be used between components. For best results:

•Use 75-ohm coaxial shielded cables.

•Use appropriate input and output connectors, that match your component connectors.

•Avoid long cables to minimize interference.

AC Power Supply Cord

CAUTION: TO PREVENT ELECTRIC

SHOCK, MATCH WIDE BLADE OF PLUG

TO WIDE SLOT OF AC OUTLET AND

FULLY INSERT. DO NOT USE A PLUG

WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.

PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS, CONVENIENCE RECEP- TACLES, AND THE POINT WHERE THEY EXIT FROM THE APPARATUS.

Remote Control Battery Installation

Requires two AA batteries (supplied).

Battery Polarity

5V.
1 /	AA
AA / 1.
5V

1 2

5A.
1	/
	AA
AA / 1.
5A

3

Procedure

1.Turn the remote control face down. Remove battery cover by pressing down on the marking on the cover and sliding it off in the direction indicated.

2.Install batteries matching (+) and (–) polarity signs.

3.Replace the battery cover by sliding in reverse until the lock snaps.

Note: Incorrect installation can cause battery leakage and corrosion that will damage the Remote Control.

Precautions

•Replace batteries in pair.

•Do not mix battery types (zinc carbon with alkaline).

•Do not recharge, heat, short-circuit, disassemble, or burn batteries.

4