Additional controls and important information.
Ventilation
The ventilation lever must be in the CLOSE position in order to maintain the best cooling conditions.
When fresh air is necessary in the room, set the ventilation lever to the OPEN position.
The damper is opened and room air is drawn out.
NOTE: Before using the ventilation feature, and prior to installing the front grille, pull down part 
until level with part 
.
Air Direction
CLOSE 
VENT 
OPEN
Part B
Part A
The direction of air can be controlled wherever you want to cool by adjusting the horizontal louver and the vertical louver.
• VERTICAL | • HORIZONTAL |
Controlled | Controlled by Remote |
manually | Controller |
The vertical air direction is adjusted | The horizontal air direction is adjusted by |
by rotating the horizontal louver | rotating the vertical louver right or left manually |
forward or backward manually. | or by Remote Controller. |
How to Secure the Drain Pipe
In humid weather, excess water may cause the BASE PAN to overflow. To drain the water, remove the DRAIN CAP and secure the DRAIN PIPE to the rear hole of the BASE PAN. Press the drain pipe into the hole by pushing down and away from the fins to avoid injury. (See Fig. 1)
Optional(CW3H02502C) |
|
|
| |
1. | Remove the rubber plug and slide the chassis out |
|
|
|
| from the cabinet. (See Fig. 2) | Drain pipe |
|
|
2. | Install the drain pan over the corner of the cabinet |
| Drain cap | Fig. 1 |
| where you removed the plug with 4 screws. |
|
|
|
| (See Fig. 3) |
|
|
|
3. | Connect the drain hose to the outlet located at the |
|
|
|
| bottom of the drain pan. You can purchase the drain |
| Remove the |
|
|
| rubber plug | Fig. 2 | |
| hose or tubing locally to satisfy your particular |
| ||
|
|
| ||
|
|
|
| |
| needs. (Drain hose is not supplied). (See Fig. 3) | CABINET |
|
|
|
|
|
| |
4. | Select the most appropriate connection from among |
|
|
|
| the figures to the right (by considering the hole of the | PAN | Inside diameter 17mm (5/8") | |
|
| DRAIN | DRAIN HOSE |
|
| unit) to fit drain pan to your own unit. (See Fig. 3) |
| SCREW | Fig. 3 |
5. | Slide the chassis back into the cabinet. Reinstall the |
|
|
|
| cabinet screws. Secure the cabinet to chassis by |
|
|
|
| using screws. (See Fig. 4) |
|
|
|
|
|
|
| Fig. 4 |
About the Controls on the Air Conditioner
7
