Panasonic DMPBDT220, DMP-BDT220 owner manual Messages, On the television, On the unit’s display

Messages

The following messages or service numbers appear on the television or unit’s display.

On the television

Cannot play.

¾You inserted an incompatible disc (Discs recorded in PAL video, etc.).

Cannot display on this unit.

¾You tried to play a non-compatible image.

¾Confirm “SD” on the unit’s display is not displayed and re-insert the card.

No disc inserted.

¾The disc may be upside down.

$This operation is not available.

¾Some operations are unsupported by the unit. For example;

–BD-Video: During playback, reverse slow-motion or reverse frame-by-frame is not possible.

IP address is not set.

¾The “IP Address” in “IP Address/DNS Settings” is “---. ---. ---. ---”. Set the “IP Address”, “Subnet Mask”, and “Default Gateway”. (Select the automatic address acquisition if necessary.)

The current wireless network security setting is weak. It is recommended to change to a stronger security setting.

¾Authentication type for the wireless LAN is set to “Open system”, or the encryption type is set to “No encryption”. It is recommended to encrypt for safety reasons. For details, refer to the instructions of the wireless router being used. Encryption is required when playing back video, etc., from DLNA compatible devices.

On the unit’s display

F99

¾The unit fails to operate properly. Press [Í/I] on the main unit for 3 seconds to switch the unit to standby, then switch back on.

HDMI ONLY

¾Some BD-Video discs can only be output with HDMI.

NET

¾While connecting to a network.

No PLAY

¾There is a viewing restriction on a BD-Video or DVD-Video. (> 29)

No READ

¾The media is dirty or badly scratched. The unit cannot play.

PLEASE WAIT

¾The unit is carrying out an internal process. This is not a malfunction. You cannot operate the unit while “PLEASE WAIT” is displayed.

REMOVE

¾The USB device is drawing too much power. Remove the USB device.

SET (“  ” stands for a number.)

¾The remote control and main unit are using different codes. Change the code on the remote control.

Press and hold [OK] and the indicated number button at the same time for more than 5 seconds.

34 VQT3V20