Panasonic EP3513 manual Cleaning and Maintenance

CLEANING AND MAINTENANCE

CAUTION

•Always unplug the unit before cleaning it. Never touch a power plug with wet hands. Failure to follow these instructions may lead to electrocution or burns.

Areas Covered with Synthetic Leather

•Wipe these areas with a soft, dry cloth. (Do NOT use cloths containing any kind of chemical, etc.)

•If the synthetic leather is particularly dirty, soak a soft cloth in water or a 3~5% solution of mild detergent, wring it out thoroughly and tap the surface with it. Next, rinse the cloth in water, wring it out thoroughly and then wipe any remaining detergent from the surface, wipe the surfaces with a soft dry cloth and allow them to dry naturally.

(Do NOT use a hair dryer to try to dry the surfaces more quickly.)

Water

Mild Detergent

•Do not allow these areas to come in contact with plastic for extended periods of time as this may lead to discoloration.

Pipe and Plastic Areas

(1)Wipe the unit with a cloth that has been soaked in a mild detergent and then thoroughly wrung out.

(2)Next wipe the unit with a cloth that has been moistened with just water and thoroughly wrung out.

*Make sure you thoroughly wring out the cloth first when cleaning the control panel.

(3)Allow the unit to dry naturally.

•Please do NOT use thinners, benzine or alcohol.

Seat Fabric

(1)Wipe the seat fabric with a cloth that has been soaked in a mild detergent and then thoroughly wrung out.

(2)Use a mild detergent and brush on areas where the seat fabric has become particularly soiled. Be careful not to brush the fabric too much as you may damage it.

(3)Next wipe the fabric with a cloth that has been moistened with just water and thoroughly wrung out.

(4)Allow the fabric to dry naturally.

Thinner Benzine

Alcohol

Mild Detergent

Water

Water

Moving the Unit

CAUTION

•Do not move the unit while someone is seated on it. Do not place objects on or sit, climb, or stand on the legrest.

•When moving the unit using the wheels, remove all obstacles from around it, make sure the backrest is in the upright position, lift it no higher than waist height (no higher than 31 in. (80 cm)) and roll it slowly. Failure to do so may cause the unit to tip over, which may lead to damage or injury.

Lifting the Unit

•Move the chair by having one person hold onto the rubber section on the underside of the legrest and another person use the handle on the back of the backrest.

*Please hold the handle and legrest securely to avoid dropping the unit as it may damage your floor.

Make sure the legrest is		Place the control
retracted to the minimum length.		panel on the seat.
Hold onto the rubber section on
the underside of the legrest.		Handle
Do not hold onto the fabric.
Rubber Section	Place your fingers in the groove.
Mat

Using the Wheels to Move the Unit

•Move the chair by holding onto the rubber section on the underside of the legrest and using the wheels.

(It is easier to move the unit when the massage heads are positioned at the top of the backrest.)

*Place a mat on the floor and gently roll the unit over it to avoid damaging the floor.

	Make sure the legrest is
Place the control	retracted to the minimum length.
panel on the seat.		Hold onto the rubber section
Roll the unit
		on the underside of the legrest.
slowly.
		Do not hold onto the fabric.

Rubber Section

Mat Wheels

35