9
Cleaning of the epilation head
Push the frame release buttons and
remove the frame.
Brush the frame.
While cleaning, you can turn the
epilation discs manually.
Be careful not to break the skin
protector when cleaning.
For disinfection of the epilation
discs please use only pure alcohol.
Attention! Wipe the main body only
with a damp cloth. The use of
alcohol etc. may cause discoloration
or deformation of the main body.
After cleaning, put the cap on the
epilation head.
Cleaning of the shaver head
Push the frame release buttons and
remove the frame.
Remove the inner blade by lifting
straight up.
Clean with the brush.
Be careful not to apply too much
force to the outer foil.
After cleaning, put the pre-epilation
comb on the shaver head.
Replacing the outer foil of
the shaver head (Fig. 5)
Never remove the outer foil for
other reason than to change it.
Removing the outer foil
While pushing the outer foil gently
with the fingers, use the fingernail
to release the plastic panel F
bon
the blade from the catches Faon
the inside of the frame.
Fitting the new outer foil
Holding the outer foil so that the
surface with the plastic panel F
b(i.e.
the surface that will contact the
inner blade) faces upward, insert
into the frame so that the catches
F
aon the frame fit into the holes on
the foil.
Safety precautions
•Use only the included adaptor
RE7-41.
•Please use the appliance at a
temperature of between 0~40°C.
• Always ensure the appliance is
operated on an electric power
source matched to its rated
voltage.
• Never operate the appliance if the
cord or adaptor are damaged or
overly hot, or if the plug fits
loosely in the power outlet.
•Keep the device away from
sources of heat or flame.
• Do not allow the appliance to be
used by, on, or near children.
• Do not allow the appliance to be
used or left in the vicinity of sinks,
bathrooms, or other high-humidity
areas, where it could be exposed
to water and moisture.
• Do not allow the appliance to be
immersed in, splashed with, or
rinsed under water.
• Do not modify the cord or damage
it in any way such as by bending,
twisting or pulling on it
unnecessarily.
• Do not wrap the output cord tightly
around the appliance.